Mace alert Solo MAS-WA-REM User Manual

|
MaS-Wa-reM
User Guide
Keychain Remote Control
Please keep these instructions in a safe place for future reference.
Kit contents:
1 Keychain Remote Control
1 12V alkaline battery (included)
1 User Guide
1. IntroductIon
The MaceAlert™ Solo Keychain Remote Control allows you to operate the MaceAlert™ Solo
Wireless Alarm Panel remotely. Using the control, the system can be armed or disarmed and
the siren can be activated instantly using the Panic function, if required.
2. operatIon
2.1 P
owering
The Remote Control includes a 12V alkaline battery. To activate, unscrew and remove the back
of the Remote Control, and carefully remove the clear plastic insulation tab from the battery.
If the battery is dislodged, replace it—noting the correct polarity shown inside the battery
compartment. Replace the battery cover.
2.2 e
nrolling
Before they can operate the system, new Remote Control devices need to be enrolled (added
to the system) as follows:
Keys
(1234 or 4-digit
1
PIN) +
K
uP the eychain
r
the emote
Description
You must be in StandBY
mode before enrolling a new
Remote Control onto the
Wireless Alarm Panel
r
emote
c
ontrol onto
Note
*To make sure you are in StandBY mode:
- Enter the default PIN " 1–2–3–4 " OR your new 4-digit PIN
- Press
- The panel will display the below image while you are in
StandBY mode:
(One beep indicates that you entered a valid PIN, three beeps
indicate that an invalid operation was performed).
c
ontrol
P
the anel