Subscribe to Our Youtube Channel
Related Manuals for Standard APC-45
Summary of Contents for Standard APC-45
- Page 1 Standard APC45 Programmable Paper Cutter Knife Replacement Guide Provided By http://www.MyBinding.com http://www.MyBindingBlog.com...
- Page 2 Knife Cover Open the lower cover. - Steps 4 through 7 are to return the knife holder to the standard height so that the knife does not Lower Cover cut into the cutting stick too deeply when installing the new knife instead of the re-...
- Page 3 APC-45 Knife Replacement Loosen the locking nuts of knife height adjusting turn buckle. - There are two locking nuts. Loosen Loosen Loosen - The right locking nut is a left-handed screw. Locking Nut Wrench Return the knife holder to the standard height.
- Page 4 APC-45 Knife Replacement The following procedures show how to remove the knife. Turn on the power switch. - The indication [REPLACE MODE] is shown on KNIFE REPLACE MODE the guide window and then it changes to [LOWER LOWER CLAMP CLAMP].
- Page 5 APC-45 Knife Replacement Remove the knife fixing screws. - Remove the fixing screws at the screw holes No.1, 3, 4 and 6. - Now the knife is supported only by the knife replacing tools at the screw hole No.2 and 5.
- Page 6 APC-45 Knife Replacement The following procedures show how to install 64 mm (2.52") or new knife. longer You cannot use the knife which [Reference] height is 64 mm (2.52") or shorter Height of the new knife is by re-sharpening. 70 mm.
- Page 7 APC-45 Knife Replacement Remove the knife replacing tools. Turn off the power switch. - The indication [LOWER KNIFE] is shown in the LOWER KNIFE guide window. Press the cutting buttons. Cutting Buttons - Knife holder lowers and stops at the lower limit.
- Page 8 The left side of positional relation of the groove shown in the figure the knife lowers. Mark below and mark. - The standard position is as shown in the figure below. The left side of the knife raises. View from the opening...
- Page 9 APC-45 Knife Replacement Fasten the locking screw. Window Mounting Screw Close the window for adjustment. - Fasten the mounting screw. Allen wrench 4 mm Tighten the fixing screws No.3, 4 Move downward and and 6. NOTE Insert the box wrench and move it down- Turn clockwise.
- Page 10 APC-45 Knife Replacement Install the knife cover. Knife Cover - After the knife cover is installed, the indication [COMPLETE PRESS "Ent"] is shown on the guide window. COMPLETE PRESS "Ent" Press the Ent key. - When is pressed, the back gauge move to the 400.0 position and the [Normal Work Mode] is...
Need help?
Do you have a question about the APC-45 and is the answer not in the manual?
Questions and answers