Carada MMS CIH SERIES Installation Instructions

Hardware Provided
4
18" x 2" x 5/8" boards
8
#8 x 1.5" wood screws (for mounting wood to wall)
1
11/64" drill bit (to drill alum. frame)
8
#8 x 1.5" pan head screws (for mounting alum. frame to wood)
8
black self tapping screws (for corner brackets)
1
extra self tapping snap
Step 1: Frame Assembly
A.
Remove the four aluminum frame members from the shipping box. Leave the screen surface rolled up. Inspect
the frame members and other contents for shipping damage. If there is any damage, please notify us
immediately at support@carada.com.
B.
Protect the frame from dirt and abrasion by
spreading it out on a smooth, clean surface.
Lay the frame members down with the
snaps facing up.
C.
Slide the end of each SIDE member, marked
with a T over the corner brackets of the TOP
frame member (also marked with a T ) and
attach with the provided black screws
(see Fig. A).
D.
Slide the bottom corner brackets (pre-
assembled to the bottom frame member) into
the SIDE frame members and attach with
the black screws.
v
IMPORTANT! Tighten the four corner
snaps down snugly against the frame after
assembly.
Step 2: Wood Mounting Block Installation
A.
First you must determine where the top of the MASQUERADE MASKING
SYSTEM will be located. Remember that there must be a minimum
clearance above the MASQUERADE for installation. Now that you have
determined where the top of the MASQUERADE frame will be located,
measure down 1 5 / and make a mark on the wall. This is where the
8
bottom
of the MASQUERADE wall bracket will be placed.
B.
Now from the mark made in step A, measure down 1
second mark on the wall. This lower mark is where the
CIH SCREEN wood mounting blocks (and the screen frame) will be placed.
The end of the wood block will likely NOT be aligned with the wall bracket
above it like you see in this photo. The photo is an example only.
MMS CIH SERIES
Assembly & Installation Instructions
v
When handling the assembled frame, pick it up by
the center of a frame member and avoid twisting the
frame, to prevent undue stress on the corner
brackets and frame members.
3
/
4
5 / and make a
16
top
of the MMS
ã2009 Carada, Inc.
Detail of corner assembly
with screws
Figure A
Figure B