SFD CH-2001B STAND Safety & Operating Instructions

SFD CH-2001B STAND Safety & Operating Instructions

Advertisement

Quick Links

Safety & Operating Instructions
CONVECTOR HEATER
CH-2001B STAND
These instructions are for your safety. Please read through them
thoroughly before use and retain for future reference.

Parts Supplied

Ref
Description
A
Main body
B
Feet
C
Screw for feet

Tools Required (not supplied)

Cross Head Screwdriver

Before You Start

Check the pack and make sure you have all of the parts listed above.
This appliance is designed for use as a supplementary heat source, it is not
intended to be the main source of heat.

Assembly Instruction

Illustration
Qty
1
2
4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CH-2001B STAND and is the answer not in the manual?

Questions and answers

Summary of Contents for SFD CH-2001B STAND

  • Page 1 Safety & Operating Instructions CONVECTOR HEATER CH-2001B STAND These instructions are for your safety. Please read through them thoroughly before use and retain for future reference. Parts Supplied Description Illustration Main body Feet Screw for feet Tools Required (not supplied)
  • Page 2: Operating Instructions

    Before using the heater, the feet (supplied separately in the carton), must be fitted to the unit. These are to be attached to the base of the heater using the 4 small self- tapping screws provided, taking care to ensure that they are located correctly in the bottom ends of the heater side mouldings.
  • Page 3: Safety Warnings

    In the event that the heater suffers an overheat – and shuts down – immediately disconnect the power by switching the electricity OFF at the plug and remove the plug from its socket. Remove any objects that may be causing the overheating, set the power switch to “0”...
  • Page 4: Care And Cleaning

    22. Children should be supervised to ensure that they do not play with the appliance. Plug Replacement This appliance is supplied with a BS1363 3 pin plug fitted with a 13 Amp fuse. Should the fuse require replacement, it must be replaced with a fuse rated at 13 Amp and approved to BS1362.
  • Page 5 Conformity with Directives Conforms with relevant European Directives. Environmental Protection Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. SFD Ltd BA22 8RT...

Table of Contents