Window Kit Installation; Operation Methods; Timer Set; Cooling/Heating And Dehumidifying Operation - EasyCool AIR01 User Manual

OPERATION METHODS

Timer set

1.Set timer-off
Press the Timer button when the unit is on. The LED will flash"_ _"five
Times. During this period press Up or Down button to adjust set time from
0.5h to 24h. It will vary 0.5h each time in 3h and 1h each time hereafter. The
set time will flash 5 times after adjusting. When it will display temperature
again. Once the set time end, the unit will turn off automatically.
2. Change the set time
When Timer is on, you can check remnant time by pressing Timer button. It
will flash 5 times. Press Up or Down button to adjust set time. The set time
can also be cancelled if you press the Timer button once again during the
flashing time
.
3.Set timer-on
Press the Timer button when the unit is off. Same as timer-off set. Once the
set time end, the unit will turn on automatically.

Cooling/Heating and Dehumidifying operation

1.Cooling/Heating operation
Press Mode button or / to choose Cool/heat mode.
Press Up or Down button or
The range is 18~30℃(64-86°F). The temperature will increase or decrease
1℃ or 1°F each time.
Press Speed button or
Press Swing button or to adjust the direction of vertical louver.
Adjust horizontal louver by hand.
2.Dehumidifying operation
Press Mode button or to choose Dry mode. The fan speed is Low,
LED displays room temperature. These cannot be adjusted.
NOTE:
1. In cool mode, when the water Injection indicates lights, you can inject
some water through the injection port before cooling operation (no
longer than High level).
2. You should drain water with the drainpipe in heat and dehumidifying
mode. The unit will stop work when water level exceeds the high level.
3. Do not use air exhaust duct when in Dry or Fan modes
4. If your room is directly exposed to the sun, draw the curtains please.
to set a proper room temperature.
to choose a proper fan speed.
7
INSTALLATION
1.Selection of Installation Place
Install the unit on a flat and dry place.
Leave at least 50cm space around the
unit(when the hose is not connected).
(Fig.5)
2.AIR Exhaust Duct Mounting Method
1) Fix the square end of the exhaust dust to
the exhaust terminal of the unit.
2) Put the other end (discharge) to the
nearest window. Leave at least 50cm
place around it.
NOTE:
The length of the air exhaust duct is between
60cm to 170cm or 180cm (adapters included).
We suggest using the minimum length of the air
exhaust dust. That can save energy for you.
This length has been designed
specifications of the air conditioner. Do not use an extension or
exchange of a different hose as that may lead to malfunction.

3. Window Kit Installation

The window kit has been designed to fit most standard vertical and horizontal
windows. However, it may be necessary for you to modify some aspects of the
installation procedures for certain types of windows. Please refer to the
illustrations. (Fig.7 and Fig.8)
especially according to
8
the