1. Manuals
  2. Brands
  3. Webasto Manuals
  4. Transmitter
  5. Telestart T80
  6. Operating instructions manual

Webasto Telestart T80 Operating Instructions Manual

Hand-held transmitter
Hide thumbs Also See for Telestart T80:
Table of Contents

Advertisement

Quick Links

See also: Operating, and Servicing Instructions , Instruction and Installation Manual
Telestart T80

Advertisement

Table of Contents
loading

Related Manuals for Webasto Telestart T80

Summary of Contents for Webasto Telestart T80

  • Page 1 Telestart T80...
  • Page 3 Deutsch Dansk English Svenska Français Norsk Italiano Suomi Español Polski Русский Nederlands...

  • Page 4: General Information

    Dear Webasto Customer ! We assume that the workshop / service center that carried out the installion ex- plained to you the operation and principle of functioning of your Telestart T80 to your complete satisfaction. With these operating instructions we would like to provide you with an overview of the use of the hand-held transmitter Telestart T80.
  • Page 5 The wireless Webasto Telestart T80 can be used to switch the Webasto Ther- mo Top, Thermo Top T, Thermo Top Z/C and Thermo Top E heaters or the ve- hicle's blower on and off at a distance of up to 600 m.
  • Page 6 Programming Telestart Transmitter 1. Place batteries into the battery compartment of the transmitter. 2. Remove fuse 1A (black) from the heater's fuse holder (voltage interruption). 3. Wait at least 5 seconds. 4. Replace fuse in heater's fuse holder and within 5 seconds press the OFF button on the transmitter for at least 1 second.

  • Page 7: Checking The Mode

    Checking the Mode Simultaneously depress and hold down the ON and OFF buttons. LED illuminates: in red: heating mode in green: ventilating mode LED extinguishes: – when the buttons are released, or – after 10 seconds Mode setting Depress the ON and OFF buttons simultaneously twice within one second.
  • Page 8 Response at the transmitter when the heater is switched on and The LED on the transmitter The signal has been received and the heater / will be lit for 2 seconds: vehicle fan switched on or off. red = Heating mode green = Ventilation mode The LED on the transmitter Error during signal transmission.
  • Page 9 NOTE: In the 'heating' mode, the vehicle's heating system is to be set to "warm" prior to leaving the vehicle. In the 'heating' and 'ventilation' modes, the vehicle's fan switch is to be turned to position 1 in the case of 3-speed blower fans, and to position 2 in the case of 4-speed blowers.
  • Page 10 NOTE: When the digital timer is used for activating the heater, the operating mode (parking heating or parking ventilation) most recently used with Telestart T80 will be selected. The operating duration, however, is governed by the digital timer.
  • Page 11 Checking and Setting the Operating Time The operating time of the heater or the vehicle's fan can be preset on the trans- mitter in increments of 10 minutes. The operating time is factory-set at 30 min- utes. NOTE: In the case of Thermo Top and Thermo Top T heaters, an operating time of 20 or 30 minutes has to be set in the 'heating' mode.

  • Page 12: Checking The Operating Time

    Checking the Operating Time Simultaneously actuate the ON and OFF buttons within one second three times in rapid succession. NOTE: The first coded flashing signal that is emitted immediately upon the third actuation of both buttons has to be includ- ed into the count.

  • Page 13: Returning To The Default Setting

    Returning to the Default Setting Press the ON and OFF buttons simultaneously for approx. 10 seconds until the LED extinguishes. Default setting: heating mode, 30 minutes. Checking the Batteries Press the ON or OFF button. Batteries Action Almost Flashes orange for 5 Replace batteries spent seconds...

Table of Contents