Important Lead Acid Battery Information
Use protective eye wear when testing, charging and/or
handling the batteries.
Do not attempt to disassemble batteries.
Contact with sulfuric acid may cause harm. Should contact
occur, wash skin and/or clothes with liberal amounts of water.
Do not throw batteries into fire; batteries so disposed may
rupture or explode.
Disassembled batteries are hazardous waste and must be
treated accordingly.
Dispose of old batteries per local regulations.
Inside this Package
- Replacement battery (1)
Before You Begin - Testing the Battery
Before you install the battery, use a voltmeter to make sure it has an
adequate charge. If the charge is less than 3.0 volts, charge the battery
externally with a current-limited variable power supply.
Hold the battery across a constant voltage source of 4.5 volts with a current
limit of 1 Amp. It takes up to 24 hours to fully charge a dead battery.
IMPORTANT: Do not apply more than 4.6 volts absolute maximum to the
battery. Do not exceed 1 Amp of current when charging. If the battery gets
hot, immediately stop charging the battery.
HRB-U30-S100
Replacement Batteries
Doc #: 12696-E, Part #: MAN-HRB-U30
1