Specifications - Radio Shack 20W Soldering Starter Kit User Manual

Clean the Desoldering Pump
After use, thoroughly clean the plunger,
cleaning shaft, O-ring, and barrel of the
desoldering tool. You can remove the tip
and barrel for easy cleaning. Coat the O-ring
and cleaning
shaft with
petroleum
jelly lubricant.
Do not use
solvents or
heat.

Specifications

Output Power .............................................................20W
Input Voltage ........................................ 120V AC, 60Hz
Maximum Temp. Output ..................... 860°F (460°C)
Power Cord............................................ SPT-1 18 gauge
Length of the Power Cord ...........................5 ft (1.5m) .
...............................................................with on/off switch
Soldering Tips ............................Copper-plated nickel
Guard Ring ............................................................ Silicone
Specifications are subject to change and improvement
without notice. Actual product may vary from the
images found in this document.
Shaft
Cleaning
and O-Ring
12
Plunger
Barrel