Victoria E-2073 Operating Instructions Manual page 26

26
q) Sewing with the twin needle
Insert the new needle, with the flat
end towards the rear.
• Pass the thread in, as for normal
sewing. The two threads are passed
together through the thread guides –
as far as the twin needle.
• It is here that the two upper threads
are threaded separately.
• Make sure that the stitch width set-
ting is no larger than "3" – otherwise
the needle will break.
r) Embroidery
• Take off the sew foot
Place the darning plate on top of the
zigzag plate, as described in Chapter 8.
Embroidery can only be done free-
hand. The material should be
clamped in the tambour and moved
around the motif as required, while
you control the speed of the needle
movements with the foot switch.
s) Thread cutter
When you have completed a seam, or if
you wish to cut the threads for any other
reason:
Simply pull the threads over the
sharp blade behind the sew foot to
cut the threads off.