Do you have a question about the 38247 and is the answer not in the manual?
Questions and answers
Summary of Contents for ProSystems 38247
Page 1
53 for the reduction of claims specified on the Performance Data Sheet. Part No.: 37081 Refer to the manufacturer’s Performance Data Sheets for the specific reduction claims and certification. Rev: A 09/07 Not approved for use in California. Please request California-specific product literature from your local ProSystems Dealer.
Table of Contents Operational Specifications................3 Product Certification Information.............. 3 Installation Instructions ................4–5 System Start Up....................5 Maintenance Requirements................6 How to Change the Filter Cartridge ............6 Troubleshooting Guide ................7 Exploded View and Parts List ..............8 Warranty Information ..................
Questions? If you have any questions regarding the installation, oper- ation or servicing of this system, please contact your local Prosystems Dealer. Your ProSystems Dealer will be familiar with your particular situation, your water conditions, etc. and should be able to address your concerns promptly and efficiently.
Installation Instructions 1. Install an Inlet Shut Off Valve (Not Supplied) • Turn off the cold water supply and open the cold water faucet to relieve any line pressure (see figure 1). • Install an inlet shut off valve (not supplied) between the existing Important Note: The shut off valve must have a 1/4 inch connection.
3. Mount the System • Position the bracket to allow for the height and width of the unit. • Mount the bracket with the two holes at the top and the single hole at the bottom. • Tilt the top of the unit towards the wall and slide the retainer band up and into the upper notch on the bracket.
ProSystems replacement filter cartridges, order number 38675, are available through your local ProSystems Dealer. If you are unable to order replacement parts from your local ProSystems Dealer, please contact ProSystems at 1-800-811-3489 for assistance. Testing Your Water...
TDS. If the troubleshooting guide did not resolve the symptom, please contact your local ProSystems Dealer for service. If you cannot locate your local ProSystems Dealer, please contact ProSystems Customer Service at 1-800-811-3489.
ProSystems or their parent company, AWTP, LLC. Any non-ProSystems product may be covered by the manufacturer of that product, and is not covered by the ProSystems warranty. AWTP, LLC does not warrant that your ProSystems product and the non-ProSystems product will perform properly when used together, and assume no liability therefore.
Need help?
Do you have a question about the 38247 and is the answer not in the manual?
Questions and answers