Rac -HP082 User Manual

MAINTENANCE

Always inspect the tool before use to ensure the cables are in good condition and
the clamps are clean and free from corrosion. Keep clean by wiping with a dry cloth. Do
not use solvents as a cleaning agent.
12 Volt output socket
A built -in protective device will limit the power when the product overloads. In this case ,
disconnect the device that provoked the overload and wait for approximately ten minutes
for unit to automatically reset before re-use.
WARNING:
• Do not use the output socket and engine starter at the same time.
• The output can be as high as 13 volts after the product has been fully charged,
consult your appliance handbook to ensure it is safe to operate.
• Do not allow the battery to be completely discharged, i.e. below 11.2V, as the charger
can not recover a deeply discharged battery.
If faults cannot be remedied, contact the Helpline on 020-83916767
Helpline@hilka.co.uk

GUARANTEE

This product is guaranteed for domestic use for a period of 12 months against faulty manufacture or materials.
This Guarantee does not affect the statutory rights of the consumer. If in the event of any problem occurring please
contact our Helpline at the number above for advice. This product is not guaranteed for HIRE purpose.
Manufactured under licence by Hilka Pro Imports.
1 ROEBUCK PLACE, ROEBUCK ROAD, CHESSINGTON, SURREY KT9 1EU
RAC-HP082 - Issue 1 - R.W. 21-12-06
400 Amp Rechargeable Jump Start System
RAC-HP082
Environmental protection
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authority or retailer
for recycling advice.