Troubleshooting For Anynet - Samsung la37b530p7f User Manual

Troubleshooting for Anynet +

¦
Problem
Anynet + does not work.
I want to start Anynet + .
I want to exit Anynet + .
The message
'Connecting to Anynet +
device...' appears on the
screen.
The Anynet + device does
not play.
The connected device is
not displayed.
The TV programme
cannot be recorded.
The TV sound is not
output through the
receiver.
Possible Solution
Check if the device is an Anynet + device. The Anynet + system supports Anynet +
●
devices only.
● Connect only one receiver (home theatre).
Check if the Anynet + device power cord is properly connected.
●
Check the Anynet + device's Video/Audio/HDMI 1.3 cable connections.
●
Check whether Anynet + (HDMI-CEC) is set to On in the Anynet + setup menu.
●
● Check whether the TV remote control is in TV mode.
Check whether it is Anynet + exclusive remote control.
●
Anynet + doesn't work in certain situations. (Searching channels, Operating
●
Plug & Play, etc.)
● When connecting or removing the HDMI 1.3 cable, please make sure to search devices
again or turn your TV off and on again.
Check if the Anynet + Function of Anynet + device is set on.
●
Check if the Anynet+ device is properly connected to the TV and check if the Anynet +
●
(HDMI-CEC) is set to On in the Anynet + Setup menu.
● Press the TV button on the TV remote control to switch to TV. Then press the TOOLS
button to show the Anynet + menu and select a menu you want.
Select View TV in the Anynet + menu.
●
● Press the SOURCE button on the TV remote control and select a device other than
Anynet + devices.
● Press P >/<, CH LIST, PRE-CH, and FAV.CH to change the TV mode. (Note that
the channel button operates only when a tuner-embedded Anynet + device is not
connected.)
You cannot use the remote control when you are configuring Anynet + or switching to a
●
view mode.
Use the remote control when the Anynet + setting or switching to view mode is
●
complete.
● You cannot use the play function when Plug & Play is in progress.
Check whether or not the device supports Anynet + functions.
●
● Check whether or not the HDMI 1.3 cable is properly connected.
Check whether Anynet + (HDMI-CEC) is set to On in the Anynet + setup menu.
●
Search Anynet + devices again.
●
You can connect an Anynet + device using the HDMI 1.3 cable only. Some HDMI cables
●
may not support Anynet + functions.
● If it is terminated by an abnormal situation such as disconnecting the HDMI cable or
power cord or a power failure, please repeat the device scan.
● Check whether the antenna jack on the recording device is properly connected.
● Connect the optical cable between TV and the receiver.
English -