Samsung GT-E1085L Service Manual page 53

Exploded View and Parts List
11-2. Assembly
1
Soldering 2 points of MIC FPCB pad with
PBA
1) Be careful not to make scratch and molding damage!
3
Combine LCD to Main Board.
Push LCD to left and make left hook takes it's
position.
CHECK POINT
1. Order of LCD combining
① Set LCD rib to it's hole
② Push and lock the hook which is at right-bottom side of LCD
③ Push and lock the hook which is at left-bottom side of LCD
1) Be careful not to make scratch and molding damage!
2) Don't push the panel of LCD while combine the LCD
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
2
Soldering FPCB of the LCD MODULE
CAUTION
Check F-PCB to MAIN PCB soldering tightly.
(If there is a gap between F-PCB and Main board will
makes faulty)
Be careful not to make Flux on the Main Board
(Use the cover of Soldering Jig)
1) Be careful not to make scratch and molding damage!
2) Be careful not to make a gap between LCD FPCB
and Main Board.
3) Height of solder should not over 0.2mm.
4
Assemble the SHIELD CAN
1) Be careful not to make scratch and molding damage!
11-4