Advertisement
Quick Links
Advertisement
Summary of Contents for AquaPower AP15AG
- Page 2 AQUAPOWER-PLUS WARRANTY Please complete on day of installation and return to PET Pool Products, Inc. PLEASE NOTE Date of purchase Always test the salt level of the pool before calculating your salt requirements. This is very important because a pool that has been treated with other forms of chlorine may already have a significant salt level in it.
- Page 3 CONGRATULATIONS AND THANK YOU FOR PURCHASING THIS QUALITY PRODUCT Manufactured and distributed by: Pet Pool Products, Inc. 305 Comstock, Suite 2-3 Chandler, AZ. 85225 Local: 480.635.8197 Local Fax: 480.635.8359 Toll Free: 1.866.725.8766 Toll Free Fax: 1.866.807.5546 www.aquapowerplus.com...
- Page 4 NOTES...
-
Page 5: Table Of Contents
WARRANTY Index Residential Applications 4. Introduction AP-RP model The power supply carries a full 2 year warranty. 5. Basic operating hints Cells carry a 2 year full, 3 year pro-rated warranty Commercial Applications 6. Control panel buttons/functions AlI models will have a 1 year warranty on power supply and electrode if installed in a commercial situation. -
Page 6: Introduction
Thank-you once again for choosing Aquapower-Plus, we trust you will be very happy. Your Aquapower-Plus chlorinator will eliminate the need to store dangerous quantities of chlorine, daily manual chlorine dosing and the risks associated with these practices. -
Page 7: Basic Operating Hints
Read the entire owners manual, seek advice from a pool professional on water balance, or contact AquaPower-Plus directly . It is important to understand not only the operation of your Aquapower-plus salt chlorinator, but indeed some basic water chemistry to ensure the pool, the equipment, you, your friends and family enjoy healthy swimming pleasure. - Page 8 Wiring of unit is complete. You just have to set your for 30 sec, the normal real time %chlorine output is then displayed. AquaPower timer to appropriate settings as indicated in your owner’s manual. Current 24hr. time is displayed. % Chlorine output, is displayed. Use UP/Down buttons to alter time ON1 is displayed, wait to see ON1 time.
- Page 9 6. Remove the plastic hose from your return fitting at the pool, and heavily chlorinated water diffusing through and damaging heater tube bundles. reattach to the large side (inlet) of your AquaPower-Plus. Fasten When 100% chlorine output is set, full power is delivered to the cell, however with a stainless steel clamp.
- Page 10 5.. ON2 - wait 2 seconds for the corresponding time to display Continue to view all four on/off times Note: If the Aquapower-plus chlorinator is unplugged, or the power is switched off, the unit will retain all the programmed settings for at least...
- Page 11 Wiring instructions for AquaPower-Plus SPECIAL FUNCTIONS All AquaPower-Plus systems are set up to operate at 220 volt from the factory. TO ACTIVATE 24 HOUR BOOST - Automatic super-chlorination Above fround units are set up to operate on 110 volt only. (For above ground The unit must be in the AUTO mode.
-
Page 12: Salt Levels And Diagnostic Display
PLUMBING FLUSH FEATURE POWER PACK - Installation guide The Aquapower-plus power pack is supplied with a mounting bracket, three screws This feature is automatic, no programming or adjustments are necessary. When in and three masonry plugs. auto mode, the cell power will automatically switch off 30 seconds before the pump The power supply has been tested and approved to attain all relevant electrical and to ensure cell housing and plumbing is flushed of concentrated chlorine. - Page 13 3/4 oz. of gas could accumulate. How to add Never add salt to the skimmer box, this will not harm your Aquapower-plus salt If an air blower is connected directly to venturi spa jets, a vented loop must be chlorinator however coarse salt granules may seize the pump impeller.
-
Page 14: Cell Maintenance
CELL MAINTENANCE SAFETY Your AquaPower-Plus chlorinator must be installed in accordance with the Self cleaning models generally require little or no maintenance. We do however installation instructions listed in this manual. recommend that periodic inspections are made to ensure debris is not obstruct- ing the cell. - Page 15 Solution: Check time clock ON/OFF periods and adjust accordingly. the recommended level. (Highly recommended for use in indoor pools and spa’s) Call your AquaPower Dealer to purchase Possible cause: Cell electrode is coated with a mineral or metal coating. Solution: Clean electrode as described in this manual.
-
Page 16: Trouble Shooting
WATER BALANCE CYANURIC ACID - CHLORINE STABILIZER The sun’s ultraviolet light breaks down chlorine, with this in mind, it is essential in The balance of your pool water is no less critical because you have installed a sunny climates to use a chlorine stabilizer. salt chlorinator.
Need help?
Do you have a question about the AP15AG and is the answer not in the manual?
Questions and answers