TW TW4040 Instruction Manual

The adventurer monobander

Advertisement

Quick Links

TW4040
The Adventurer Monobander
TransWorld Antennas
INSTRUCTION MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TW4040 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for TW TW4040

  • Page 1 TW4040 ™ ™ The Adventurer Monobander TransWorld Antennas INSTRUCTION MANUAL...
  • Page 3: Table Of Contents

    Due to continual product improvements, the information in this manual is subject to change any time without notice. TransWorld Antennas will be held free from liability, any problems arising from the use of this manual or the products described herein. Manual Rev V1.0 TW4040 Instruction Manual...
  • Page 4: Limited Warranty

    This warranty gives you specific rights. Other rights may apply, which vary from state to state. An optional extended limited warranty purchased from TransWorld Antennas extends the period of this warranty to 24 months or 36 months, depending on warranty product purchased. TW4040 Instruction Manual...
  • Page 5: Important Safety Information

    5. While your antenna is on Tx mode (transmitting) DO NOT stand nearby. 6. It is recommended to strictly respect the maximum power settled by law and follow the instructions manual of the product. 7. Stick self-adhering “DANGER” label at eye level on your mast. TW4040 Instruction Manual...
  • Page 6: Specifications

    The TW4040 is a center fed vertical dipole antenna with a very low radiation take-off angle (around 27 degrees above horizontal), allowing for very long skips using low power on 40 meters.
  • Page 7: Vswr Performance

    VSWR of 1.5:1 or less. Test conditions: 100 feet of quality RG8/U coax, 100W output power, antenna mounted approx. 24” above ground with no external objects, metallic or otherwise, within 20ft radius of the antenna. TW4040 Instruction Manual...
  • Page 8: Unpacking

    Save all packaging materials! The original shipping materials may serve as a very handy travel box for portable applications. Also, if the antenna is returned for warranty or money-back guarantee claims, all original packaging materials will be required for approved shipping. TW4040 Instruction Manual...
  • Page 9: The Components Of Your Antenna

    See below for a summary of these four components. Top Section 32.2” x 6.25” x 3.8” Middle Section 30.13” x 7.41” x 4.88” Bottom Section 33.75” x 6.25” x 3.8” Permanent Mounting Assembly 48.00” x 3.20” x 1.25” TW4040 Instruction Manual...
  • Page 10: Getting Started

    TW4040 TransWorld Antennas 6 Getting Started Getting started with your new TW4040 is quick and easy. Follow these steps to get started using your new antenna right away. 6.1 Tools Needed A small Phillips screwdriver should be the o n l y...
  • Page 11 Second, attach the middle section to the top section as shown in step 2 below. Again, the clamp knob stud should fully engage with the slots on the end of the top section. Tighten the clamp knob snugly. TW4040 Instruction Manual...
  • Page 12 Permanent Mounting Assembly’s insulator rod. As with assembly above, the slots on the end of the bottom section should fully engage with the mounting assembly’s clamp knob stud. Firmly tighten the clamp knob. TW4040 Instruction Manual...
  • Page 13: Connections

    Coax cable. Connect your coax cable to your radio and to the SO-239 on the TW4040’s loading array box. It is highly recommended to use at least 65 feet of coax on your TW4040. For best performance, use a high quality RG-8 or RG-8X coax cable.
  • Page 14 2) Tune. Determine to what frequency the antenna is best tuned. If you wish to increase the tuned frequency, spread open both “Coils A” and “Coils B” on the circuit board, as shown in the figure below. TW4040 Instruction Manual...
  • Page 15 TW4040 TransWorld Antennas TransWorld Antennas Tk/lf040 Spreading coils increases tuned frequency Coils Coils TW4040 Instruction Manual...
  • Page 16 TW4040TM Instruction Manual...
  • Page 18 Is your coax installed at a 45-degree angle with respect to the antenna as in the figure on page 11? Are you checking the VSWR using less than five watts? Once at least five watts is applied to the antenna, VSWR readings may improve significantly. TW4040 Instruction Manual...
  • Page 19: Schematics

    TW4040 TransWorld Antennas TW4040 TransWorld Antennas 7 Schematics This page contains the schematics for the TW4040’s TW-RB-3 loading array. TW-RB-3 Loading Array TW4040 Instruction Manual...
  • Page 20 TW 4040 Instruction Manual...
  • Page 22: Contact Information

    Use this email address for help with installation, setup, tuning, or operation, for product or company information, or warranty/money back guarantee claims. Check back at our website frequently for product updates at: www.transworldantennas.com We can also be reached through our web-based contact system on the website. TW4040 Instruction Manual...

Table of Contents