Com.X10
Quick Start Guide
Version
July 15, 2014
Welcome to the world of Com X changing the communications landscape for good
This leaflet will help you to get started with your new Com X
networking and installation of the Com X
Administrator s guide
http
guide
ver
pdf
For product user manuals and user guides are available at
Description
The Com X
supports two variants of hardware build
Traditional PBX ISDN and or Analogue support
IP Gateway ISDN only no analogue support
"Traditional PBX": ISDN and Analogue support
The figure above shows the rear panel view of the traditional PBX Com X
casing that supports Primary Rate ISDN
ports up to
ports FXS or FXO and any combination thereof All telephony hardware interfaces are
modular availability of thereof is dependent on the Com X
Two
port slots are available for Analogue line cards numbered a
with octal FXO or octal FXS cards providing eight RJ
interface is designated a
unit and SHOULD be read in conjunction with the Com X
www farsouthnet com wp content uploads
PRI port Basic Rate ISDN
to a
and a
to a
Copyright © 2008-2014 Far South Networks (Pty) Ltd
http://www.farsouthnet.com
solution This getting started guide addresses
http
www farsouthnet com support manuals
build variant This layout has a
BRI ports and Analogue telephony
build to order
a
Each a
ports numbered to
Com X administrator
a slot may be installed
Thus each analogue RJ
Need help?
Do you have a question about the Com.X10 and is the answer not in the manual?
Questions and answers