Volvo S60 Owner's Manual page 118

03 Your driving environment
Starting the engine
Deactivated functions
When the engine is started with ERS, the fol-
lowing functions are deactivated:
•
Headlights
•
Parking lights
•
License plate lights
03
•
Windshield wipers
Switching off an engine started with ERS
Any of the following will switch off the engine if
it has been started with ERS:
•
Pressing the lock button (1) on the remote
key
•
Unlocking the vehicle
•
Opening a door
•
Depressing the throttle or brake pedal
•
Moving the gear selector from the P posi-
tion
•
If there are less than approx. 2.5 gallons
(10 liters) of fuel in the tank
•
More than 15 minutes have elapsed.
If the engine has been started with ERS and
switches off, the turn signals will illuminate for
3 seconds.
Message in the instrument panel display
If ERS is interrupted, a text message will be
displayed in the instrument panel.
116
Switching off the engine
With the engine running, press the START/
STOP ENGINE button.
If the gear selector is not in the P position or if
the vehicle is moving, press the START/STOP
ENGINE button twice or press and hold it in
until the engine switches off.
Jump starting
Connecting the jumper cables
Follow these instructions to jump start your
vehicle's dead battery or to jump start another
vehicle's dead battery using your vehicle. If the
12-volt auxiliary battery to be used is in another
vehicle, check that the vehicles are not touch-
ing to prevent premature completion of a cir-
cuit. Be sure to follow jump starting instruc-
tions provided for the other vehicle.
I n f o r m a t i o n P r o v i d e d b y :
To jump start your vehicle:
1. Switch off the ignition (set the ignition to
mode 0, see page 84).
2. First connect the red jumper cable to the
auxiliary battery's positive (+) terminal (1).
3. Fold back the cover over the positive (+)
terminal on your vehicle's battery (2),
marked with a "+" sign, located under a
folding cover.
4. Connect the black jumper cable to the aux-
iliary battery's negative (–) terminal (3) and
to the ground point in your vehicle's engine
compartment (right engine mount at the
top, on the outer screw) (4).
5. Start the engine in the assisting vehicle,
then start the engine in the vehicle with
dead battery.
6. After the engine has started, first remove
the negative (–) terminal jumper cable
(black). Then remove the positive (+) termi-
nal jumper cable (red).