Ubertronix Strike Finder Touch Manual

Strike Finder T ouch
T
he Strike Finder Touch is our top of the line device and features 5 fully-programmable functions designed
to capture images that would

Technical Information:

When you first turn on the device, it will "boot-up", indicated by a 1-
•
second red flash of the Trigger LED, the screen will launch to the
Ubertronix start page.
If the Trigger LED doesn't flash or the screen does not turn on, please
•
replace the batteries. (The screen may also flash in green words
"Mounting" or "Device not Mounted..."), this also indicates low batteries.
Every time the LED blinks, your camera or flash will fire.
•
There are three ports on the side of the device (Sound, Motion, and
•
Camera). The CAM port is used to plug in either a sync cable (attached
to a flash) or a camera cable.
The device sits in the hotshoe only for convenience, it is not required to release the shutter.
•
The device uses 4 AAA batteries and will perform for 3 hours with the screen on and 5 hours with the
•
screen off.
To turn on the power saving feature, simply tap the Power Save button (note: all settings are remembered
•
while in power save mode). To turn the screen back on, tap the screen in the same location as the Power
Save button.
When plugging in the external sensors, turn the device off.
•
Please see below for more specific information on each screen.
•
Copyright 2010-2014 All Rights Reserved. Ubertronix, Inc.
otherwise be humanly impossible to do.