Related Manuals for Lava Heat Italia LAVA 2G
Summary of Contents for Lava Heat Italia LAVA 2G
- Page 1 For sales inquiries, contact Sylvane at 1-800-934-9194. If you have service questions, contact Lava Heat at 1-888-779-5282.
- Page 2 Owner’s Manual LAVA 2G DANGER If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. If odor continues, keep away from the appliance and immediately call you gas supplier or fire department. WARNING WARNING indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
-
Page 3: Package Contents
PACKAGE CONTENTS Reflector Mesh Glass Tube Fixer Top Plate Support Protective Guard Glass Tube Black Silicone Ring Control Box Assy Side Panel Block Belt Gas Hose & Regulator Wheel Front Panel Bottom plate Handle Handle Support Ceramic Fiber QUANTITY QUANTITY Reflector Bottom plate Mesh... -
Page 4: Safety Information
HARDWARE CONTENTS (shown actual size) Wing nut Qty. 3 Bolt M6 X 10 Qty. 8 Wrench Qty. 1 SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. This manual contains important information about the assembly, operation and maintenance of this patio heater. - Page 5 SAFETY INFORMATION DANGER DANGER • EXPLOSION - FIRE HAZARD • CARBON MONOXIDE HAZARD • Keep solid combustibles, such as building materials, • This heater is a combustion appliance. All paper or cardboard, a safe distance away from the combustion appliances produce carbon monoxide heater as recommended by the instructions.
-
Page 6: Burn Hazard
SAFETY INFORMATION WARNING WARNING California Proposition 65 • This product is fueled by propane gas. Propane gas Combustion by-products produced when using is invisible, odorless, and flammable. An odorant is this product contain chemicals known to the State normally added to help detect leaks and can be of California to cause cancer, birth defects, and described as a “rotten egg”... - Page 7 ASSEMBLY INSTRUCTIONS 1. Heater is preassembled at the factory. User needs to complete a couple of assembly procedures to make the appliance operational. Please ensure all transit protection (foam, cardboard, bubble wrap,etc) is removed. In the next few steps you will be shown how to properly remove the bubble wrap material used to protect the boroscilate glass tube located in the center of the unit.
- Page 8 ASSEMBLY INSTRUCTIONS 3. You will need to remove at least one of the protective steel guards (E) in order to safely remove the bubble rap material from the boroscilate glass tube located in the center of the unit. Unscrew 1 of the M5x12 screws and 1 of the fixing brackets (GG), then remove the protective steel guard from its upper supports slots.
- Page 9 ASSEMBLY INSTRUCTIONS 5. Now that you have properly and carefully removed all transit protection materials from the unit, you will need to place the unit back in its original proper order. We will revisit the last several steps in reverse order. First, re-install the boroscilate glass tube (F).
- Page 10 ASSEMBLY INSTRUCTIONS 7. Lean the heater carefully. Install 3pcs studs (CC) on the top plate,secure them with 3pcs M8 cap nuts (II). Assemble the mesh base to the stud,secure them with 3pcs M8 nuts (HH). Secure the mesh to the mesh base with 3pcs Screw M5X12(DD).
- Page 11 ASSEMBLY INSTRUCTIONS 9. Open the side panel, assemble the wheel assembly to the bottom plate using 8pcs M6x10 screws (CC). Hardware Used Bolt M6 X 10 Wrench 10. Open the front panel, and then open the lid of the battery compartment and insert 2 batteries type D (flashlight batteries DC1.5v each) considering the correct polarity.Close the lid.Return the side panel in place.
- Page 12 ASSEMBLY INSTRUCTIONS A dented, rusted or damaged propane cylinder may be hazardous and should be checked by your cylinder supplier. Never use a propane cylinder with a damaged valve connection. The propane cylinder must be constructed and marked in accordance with the specifications for LP gas cylinders of the U.S.
- Page 13 OPERATION INSTRUCTIONS Leak Check WARNING leak tested and do not leak. Hose / Regulator connection Regulator / Cylinder connection 1. Make 2-3 oz. of leak check solution (one part liquid dishwashing detergent and three parts water). 2. Apply several drops of solution where hose attaches to regulator. 3.
- Page 14 OPERATION INSTRUCTIONS DANGER Caution: Do not attempt to operate until you have read and understand all General Safety Information in this manual and all assembly is complete and leak checks have been performed. Note: This heater is equipped with a pilot light that allows for safer startups and shutdowns. Pilot must be lit before main burner can be started.
- Page 15 OPERATION INSTRUCTIONS 4. Press the DOWN button to switch to lower temperature setting and UP button to switch to higher temperature setting. TO TURN OFF THE HEATER 1. Press the POWER button. 2. Turn off the valve of the gas cylinder and disconnect the cylinder. WARNING: 1.
-
Page 16: For Your Safety
For sales inquiries, contact Sylvane at 1-800-934-9194. If you have service questions, contact Lava Heat at 1-888-779-5282. OPERATION INSTRUCTIONS WARNING WARNING FOR YOUR SAFETY FOR YOUR SAFETY Be careful when attempting to manually ignite this Heater will be hot after use. Handle with extreme care. heater. -
Page 17: Care And Maintenance
OPERATION INSTRUCTIONS 9. Heater is away from gasoline or other flammable liquids or vapors. 10. Heater is away from windows, air intake openings, sprinklers and other water sources. 11. Heater is at least 24 in. on top and at least 36 in. on sides from combustible materials. 12. - Page 18 CARE AND MAINTENANCE Gas odor with extreme yellow tipping of flame. Heater does NOT reach the desired temperature. Heater glow is excessively uneven. Heater makes popping noises. Spiders and insects can nest in burner or orifices. This dangerous condition can damage heater and render it unsafe for use.
-
Page 19: Troubleshooting
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Cylinder valve is closed Open valve Clean or replace orifice or Blockage in orifice or pilot tube pilot tube Open gas line and bleed it Pilot won’t light Air in gas line (pressing control knob in) for no more than 1 - 2 minutes or until you smell gas Low gas pressure with cylinder valve... -
Page 20: Ten -Year Limited Warranty
When You Receive Your Product: If Your Product is.. oduct Feedback Please contact the manufacturer: LAVA HEAT ITALIA 888.779.5282 or LAVA HEAT ITALIA Toll free No.: 1.888.779.LAVA 1.888.779.5282 Addr.: 5999 Malburg Way, Vernon, CA, 90058... -
Page 21: Replacement Parts List
REPLACEMENT PARTS LIST Reflector Mesh Glass Tube Fixer Top Plate Support Protective Guard Glass Tube Black Silicone Ring Control Box Assy Side Panel Block Belt Gas Hose & Regulator Wheel Front Panel Bottom plate Handle Handle Support Ceramic Fiber QUANTITY QUANTITY Reflector Bottom plate...