Page 1
1 Tube Microphone Amplifier M 222 (without capsule) info@m222.de 1 Power Supply NT 222 AC with filter, attenuator, line driver 1 Microphone Cable KS 5 U, 5 m for connecting the M 222 to the NT 222 AC 1 Popscreen B5 1 Microphone Clamp SG20...
Page 2
Connect your new Tube Microphone Amplifier M 222 via the included Microphone Cable KS 5 U (5 m) to the NT 222 AC. Screw the SCHOEPS Colette capsule of your choice or the wanted Active Accessory onto your M 222. Keep in mind that when using any Active Accessory your signal path does not start with the tube but with the FET of your KC, RC, CUT1 or BLM03C.
Page 3
30 kHz (depending on the capsule type). UNBAL. When connecting your Tube Microphone M 222 to an unbalanced input loss of level may occur. You can avoid this by switching on "UNBAL." (for unbalanced operation) or (maybe better near stronger magnetic or electrical fields) connect - phase (pin 3 of your XLR-3) and ground (pin 1 of your XLR-3) close to your recording equipment (with "UNBAL."...
Page 4
ATT. -10dB Technical Data M 222 with NT 222 AC The Tube Microphone M 222 accepts sound pressure levels up to 142 dB without attenuation. Output voltage then can reach 10 V rms (measured with SCHOEPS Mains voltage: 220 V (180 .. 240 V), one fuse 50 mA slow omni MK2S, without load).
Need help?
Do you have a question about the M 222 and is the answer not in the manual?
Questions and answers