Warranty Broadcast Host is covered by a 2-year warranty to be free from defective workmanship and materials. In the event that the Broadcast Host needs repair, you must call us to get an authorization, and then carefully pack and ship it to us. You will pay for shipping to us and we will pay for return back to you, UPS ground.
Page 2
Introduction FCC Registration (cont) Broadcast Host will allow you to send and receive audio over Repair Instructions f it is determined that your telephone equipment is malfunctioning, analog telephone lines. While this may seem like a simple the FCC requires that it not be used and that it be unplugged from task that any telephone can do, the challenge is getting the the modular outlet until the problem has been corrected.
Page 3
Changes or modifications not expressly approved by JK Audio can void the user's authority to operate the equipment.
Page 4
Features (cont) Specifications Call Button - Press this button to answer or place a Inputs: telephone call (takes the line off-hook). Send 1: Balanced Female XLR, 1k ohm, -10 mV RMS Drop Button - Press this button to drop (hang up) a call. (-35 dBv nom) Mic/Line pad switch = +4 dBv max Send 1 Level - Adjusts the signal level that you are...
Page 5
Contact your JK Audio dealer for additional information. Guest Module remote Remote Control Jack - 8 pin modular jack for connection to keypad not available for sale in Europe, Australia or New Zealand.
Page 6
Send Audio - Connect a microphone or mixing console output your speech is being clipped or distorted. In this case you XLR cable to the Send jack on the Broadcast Host. Be sure to should back down on the Send volume control for the input that set the Broadcast Host mic/line switch to the proper position for is causing the clipping.