Wald BICYCLE BASKET Assembly Instructions

with handle & mounting holder
- Basket easily removed for carrying
- Sized for grocery bag & many other uses
- Rust resistant durable finish
- Extended Mounting Holder allows clearance for shifters, brake
levers & cables
7
HOLDER SLOT
HOLDER
TOP BRACKET
4
HANDLEBAR
CLAMP
BRACE
MOUNTING HOLDER
BOTTOM HOOKS
6

ASSEMBLY INSTRUCTIONS

- Loosely assemble
holder with short screws. In most cases brace will be angled
2
upward toward Stem as shown.
- Center holder and hang
(If clamping onto 7/8" portion of handlebar, insert rubber spacer
strips between holder and handlebar). Loosely assemble two
handlebar clamps with long screws.
4
- Attach basket to holder
- Hold basket so
- Center basket with holder and insert lower basket frame wire over
bottom hooks of holder as shown.
- Raise handle upright and insert
slot at top of holder.
7
- Lay handle flat to lock.
- Adjust holder
1
is in proper position.
- Remove basket from holder
- Raise basket handle upright.
- Pull away from holder and lift basket from bottom hooks of holder.
- Tighten all holder fittings securely.
BICYCLE BASKET
5
LOCK END
3
1
brace onto two vertical side wires of
1
holder top brackets over handlebar.
3
lock end of handle is toward holder.
5
brace vertically on holder side wires until basket
LONG SCREW
SHORT SCREW
lock end of handle through
5
! WARNING
DO NOT overload basket.
Overloading basket may cause difficulty
in steering and/or loss of bicycle control
which could result in injury.
Mfgr.No.3133GB (Black)
Made in U.S.A. by Wald
2
MOUNTING
HOLDER
2009 Wald LLC
C
Rev.A 4/8/2009