Related Manuals for Xenios 2TouchPOS
Summary of Contents for Xenios 2TouchPOS
- Page 1 2TouchPOS Wall Mount User’s Guide 2013 Xenios LLC 82 Saint Paul Street Rochester, NY 14604 Phone 585.325.5242 • Fax 585.325.6989...
- Page 2 Contents About this Document ........................3 Removing the Hard Drive ......................4 Placing Hard Drive Directly into Posiflex Screen ..............8 Attaching Posiflex Touch Screen to Wall Mount ..............12 Xenios LLC @2013 Page 2...
-
Page 3: About This Document
About this Document This document was written for 2TouchPOS version 3.03.4900. Xenios LLC @2013 Page 3... -
Page 4: Removing The Hard Drive
Removing the Hard Drive 1. First, you will turn off the power to your Posiflex terminal. Tilted the Posiflex terminal back and unplug power cable. Xenios LLC @2013 Page 4... - Page 5 2. In the front part of your Posiflex terminal, there is a plastic plate; you will remove plastic plate to expose the hard drive. Press down on the clip release and remove plastic plate. 3. Using a Phillips head screwdriver, unscrew the single screw. Xenios LLC @2013 Page 5...
- Page 6 4. Pull down on the metal bar and slide hard drive tray out. Xenios LLC @2013 Page 6...
- Page 7 5. Unscrew all four screws and remove hard drive. Xenios LLC @2013 Page 7...
-
Page 8: Placing Hard Drive Directly Into Posiflex Screen
1. Remove Base Terminal stand by pressing plastic clip, located on the backside of your terminal. Hold the clip, place other hand on the terminals front side of your Posiflex touch screen and lift screen up. Xenios LLC @2013 Page 8... - Page 9 2. Place your Posiflex touch screen on a flat clean surface. Disconnect hard drive power and sata cables. 3. Top right hand corner of the terminal, there are two screws you will remove, then take plastic plate off. The hard drive will be placed into here. Xenios LLC @2013 Page 9...
- Page 10 4. Once plastic plate is removed, you will see two cables, hard drive power and sata cable. Xenios LLC @2013 Page 10...
- Page 11 5. Connect hard drive with hard drive power and sata cables. 6. Once cables are attached, slide hard into drop down area. Reattached plastic plate with the two screws. Xenios LLC @2013 Page 11...
-
Page 12: Attaching Posiflex Touch Screen To Wall Mount
Using a drill, drill holes and place anchors into wall. Screw in screws into Make sure your mall anchors. Match up wall mounting bracket to screws in the wall. mount is secure before hanging your Posiflex touch screen. Xenios LLC @2013 Page 12... - Page 13 Match the four terminal braces with wall mount (flat Again, make sure everything is side). Slide Posiflex Touch screen onto to wall mount. secure before letting go of touch screen. Xenios LLC @2013 Page 13...
- Page 14 5. Once Posiflex screen is mounted on wall, re-connect power, and sata cables. Xenios LLC @2013 Page 14...