Advertisement
Quick Links
Advertisement
Related Manuals for O-Synce ANT+ remote
Summary of Contents for O-Synce ANT+ remote
- Page 1 ANT+ remote User manual...
- Page 2 ANT+remote parts The ANT+remote has three buttons, which are marked with the symbols (▲, ▼ and ●). Additionally there is a red/green LED located at the center. To mount the remote control a handlebar adapter and various rubber rings are provided. Mounting of ANT+remote Attaching on a bar The ANT+remote can be mounted on the left or on the right side of a handlebar...
- Page 3 1. Remove yourself at least 40m for the "pairing" process from other similar ANT+™ devices. 2. Bring the ANT+remote in the near (1m) of the o-synce head unit (e.g. navi2coach). 3. Please press and hold the upper and lower button (▲ and ▼) for about 2...
-
Page 4: Key Functions
After replacing the battery, the ANT+remote must be paired to the head unit (e.g. navi2coach) again. Key functions Turn off your ANT+remote The ANT+remote will switch automatically to standby mode after 30 seconds, when the head unit is no longer activated. Replacing the battery If the status LED flashs during operation periodically red, the battery will drain almost completely and should be replaced. -
Page 5: Technical Specifications
Overview of Status-LEDs The following table shows an overview of the different operating conditions of the ANT+remote. Please make sure that the ANT+remote is activated by pressing the middle key. If the connection of ANT+remote to your head unit will not be established correctly or even terminated, the ANT+remote will switch automatically to standby mode after 30 seconds. -
Page 6: Warranty
Batteries are excluded from warranties. In case of a warranty please contact the retailer where you purchased your device. Batteries can be returned after use. This product is compliant with the Directive 1999/5/EC. The relevant Declaration of Conformity is available at http://www.o-synce.com/en/customer- support.