Table of Contents
Summary of Contents for KanPak CDG-211
- Page 1 CDG Series Liquid Dispensers CDG-211 CDG-311 NORTH AMERICAN OPERATORS MANUAL KanPak LLC, 425 Main Street North, Southbury, CT 06488 Phone: 800.569.0826 or 203.264.7203 • Fax: 203.264.7292 • Email: kpservice@kanpak.us www.kanpak.us 8-0500-0003 - 20121212...
-
Page 2: Table Of Contents
DISPLAY………………………………………………………. 7 LCD…………………………………………………….. 7 LED INDICATOR…………………………………… 7 TROUBLE SHOOTING GUIDE…………………………. 8 KanPak LLC DRAWINGS 425 Main Street North CDG-211 H DIMENSIONS…………………….. 9 Southbury, CT 06488 CDG-211 HT DIMENSIONS…………….…….. n/a Phone: 800.569.0826 or 203.264.7203 CDG-211 V DIMENSIONS…………………….. 11 Fax: 203.264.7292 Email: kpservice@kanpak.us... -
Page 3: Introduction
Examine the dispenser for damage. Report any damage to the transportation company immediately. File a claim for damages promptly. Your immediate inspection protects you against loss since KanPak is not responsible for damages incurred during shipment. SAFETY KanPak, LLC strives to design robust equipment where safety, simplicity and efficiency are paramount. -
Page 4: Specifications
Cold Wall Evaporation 1/6 HP Compressor 134a Refrigerant, 165 Grams Certifications NSF/ANSI Standard 20 UL Standard 471 CSA C22.2 No.120 KanPak LLC, 425 Main Street North, Southbury, CT 06488 Phone: 800.569.0826 or 203.264.7203 • Fax: 203.264.7292 • Email: kpservice@kanpak.us www.kanpak.us Page 2... -
Page 5: Unpacking The Dispenser
Packaging for reshipment is done in the reverse order of unpacking. If packaging is not available, it can be purchased locally, or from KanPak by request. Any damage occurring in transit of the returned goods caused by improper packaging is not considered a defect covered by warranty. -
Page 6: Installation And Location
Interior compartment thermometer will indicate 32°F to 40°F (0°C to 5°C). Locate the Drip Tray and install the Bag-In-Box Shelf (or optional accessory). Load pre-chilled KanPak product of your choice, as instructed. Close the dispenser door and secure latch. -
Page 7: Loading Product
LOADING PRODUCT KanPak CDG Series dispensers are manufactured to be used in with prepackaged Bag-In-Box products. Ensure the dispenser has achieved proper operating temperature by running empty for one hour before loading pre-chilled product to be dispensed. Product must be pre-chilled prior to loading it into the dispenser. Product temperature range must be between 32°F to 40°F (0°C to 5°C). -
Page 8: Operation
OPERATION When the initial startup is complete, operating your CDG Series dispenser is simple. • Place cup under the product tube. • Push lever down for the desired quantity and product. • Load product as needed. • Perform preventative maintenance as outlined. MAINTENANCE Though the preventative maintenance of your CDG Series dispenser is minimal, these few steps are important for continued operation to maximize the life of this appliance. -
Page 9: Display
“ALWAYS FRESH DEF” = Automatic defrost in progress. “ALWAYS FRESH ERR” = Service is required. ALWAYS FRESH DEF Contact KanPak Equipment Service when unit requires servicing. LED INDICATOR CONFIRMS POWER POWER LED turns ON by switching the power control switch ON. -
Page 10: Trouble Shooting Guide
15 minutes have elapsed. Compartment has ice and/or Perform the standard preventative frost build-up. maintenance (PM) as outlined. The temperature control Contact KanPak Equipment Service. requires adjustment. ERR on Display, or The unit requires servicing. Contact KanPak Equipment Service. Flashing Yellow LED... -
Page 11: Drawings
DRAWINGS Page 9... - Page 12 DRAWINGS This page is intentionally left blank. Page 10...
-
Page 13: Cdg-211 V Dimensions
DRAWINGS Page 11... -
Page 14: Cdg-311 H Dimensions
DRAWINGS Page 12... -
Page 15: Cdg-311 Ht Dimensions
DRAWINGS Page 13... -
Page 16: Cdg-311 V Dimensions
DRAWINGS Page 14... -
Page 17: General Parts List
CDG-211 H PARTS DIAGRAM Page 15... - Page 18 CDG-211 V PARTS DIAGRAM Page 16...
-
Page 19: Warranty
The operator will arrange for the out-of-service dispenser to be shipped to KanPak in Southbury, CT. Once the out of service dispenser is received by the KanPak service center and it has met the conditions of the warranty, KanPak will cover the shipping costs to ship a dispenser back to the customer’s original shipping location. - Page 20 KanPak LLC 425 Main Street North Southbury, CT 06488 Phone: 800.569.0826 or 203.264.7203 Fax: 203.264.7292 Email: kpservice@kanpak.us www.kanpak.us...