Installing The Projector; Battery Installation - Sony VPL-FX51 Operating Instructions Manual

Location and Function of Controls / Installing the Projector
ql APA (Auto Pixel Alignment) key
w; VOLUME +/− keys
This key does not work in the unit.
wa LENS key
This has the same function as the LENS CONTROL
key on the control panel.
ws PJ/NETWORK select switch
To use the Remote Commander for network
operations, set the switch to NETWORK. Set the
switch to PJ to use the Remote Commander for
normal operations other than networking.
wd COMMAND ON/OFF switch
When this switch is set to OFF, no key on the Remote
Commander function. This saves the battery power.
wf Transmission indicator
Lights up when you press a key on the Remote
Commander.
wg Infrared transmitter
wh Laser transmitter

Battery installation

1
Push and slide to open the lid, then install the two
size AA (R6) batteries (supplied) with the correct
polarity.
Be sure to install
the battery from
the # side.
2
Replace the lid.
Notes on batteries
• Make sure that the battery orientation is correct when
inserting batteries.
• Do not mix an old battery with a new one, or
different types of batteries.
• If you will not use the Remote Commander for a
long time, remove the batteries to avoid damage
from battery leakage. If batteries have leaked,
remove them, wipe the battery compartment dry and
replace the batteries with new ones.
Notes on Remote Commander operation
• Make sure that there is nothing to obstruct the
infrared beam between the Remote Commander and
the remote control detector on the projector.
• The operation range is limited. The shorter the
distance between the Remote Commander and the
projector is, the wider the angle within which the
commander can control the projector.
14
(GB)
Ofrecido por www.electromanuales.com

Installing the Projector

This section describes the installation arrangements
for installing the projector.
Horizontal center
of the screen
Vertical
center of
the screen
Installation
area
Projection distance
The distance between the lens and the screen
varies depending on the screen size.
Refer to the chart on page 28 (GB).
Adjust the vertical and horizontal positioning of the projector.
Vertical positioning (side view)
Screen
You can adjust the angle of projection by performing the shift
adjustment (page 19 (GB)). Install the projector so that the
center of the lens is between the bottom edge of the screen
and the center of the screen.
Horizontal positioning (top view)
Screen
Adjust the horizontal positioning of the projector so that the
center of the lens is aligned with the horizontal center of the
screen.
Install the projector so
that the tip of the lens
is within this area.
Adjustable
shift range
Center of the projector