Advertisement
INSTALLATION
1. Turn off the devices to be connected together.
2. Connect the HDMI cable between the source (DVD, Satellite
Receiver, etc.) and the "HDMI In" port of the Distribution Amplifier.
3. Connect the HDMI cables from the outputs of the distribution amplifier
to the inputs of the monitors.
4. Power up the Distribution Amplifier and the Monitor connected to
HDMI output number one on the amplifier. Leave the other monitors
off for now.
5. Turn on power to the source device. The monitor connected to output
number one should have picture and sound within about 5 seconds.
6. Turn on power to the remaining monitors.
7. Install cable ties on the Cable Retention Brackets if desired to
prevent accidental unplugging of the HDMI cables.
NOTES:
• All monitors connected to the distribution amplifier should be
capable of the same resolution.
• Always connect the first monitor to output number one on the
Distribution Amplifier first. This is necessary for the Electronic ID to
be read properly by the source.
• For optimum performance, try to use HDMI cables no longer
than 5 meters in length.
3
Advertisement
