Specifications - Sign Video Proc Amp Instruction Manual

General
Input level
Output level
`
Distortion:
Frequency response
Signal to noise ratio
Resolution (see note)
Control adjustment ranges
luminance black:
luminance gain:
Chroma saturation:
Chroma hue:
Miscellaneous
Mono mode:
Color System
Dimensions
Power Requirements
Cabinet construction
Note about resolution: Like specifying camera sensitivity without stating a signal to noise ratio, specify-
ing resolution without also stating a response level is meaningless. We have stated resolution at full re-
sponse (-1.0 dB ) and at mild degradation (-6dB). When comparing specs with other manufacturers, be
sure to ask how it was measured.

SPECIFICATIONS

1v p-p nominal to 75Ω . Works with 0.5-1.5 v p-p.
Normal mode:
Same voltage as input ±.5 dB. to 75Ω
SYNC shaped mode:
1v p-p for 100% meter reading
Composite in/out:
Differential gain: 1% max.
Differential phase: 1° max.
Y/C in/out:
Luminance channel differential gain at
3.58MHz: 1% max.(measured with black &
Composite in/out:
±1.0 dB to 10 MHz. (including any Y/C
Y/C in/out:
±1.0 dB to 10 MHz.
Better than 60 DB (including HUM & noise)
800 lines at no more than 1.0 db down. (see note)
1600 lines at no more than 6 db down. (see note)
±15 IRE
-40 dB to +6 dB
-35 dB to +6 dB
±35° min.
Burst suppressed to -40 dB min.
NTSC, 3.58 MHz.
9.17" wide, 2.45" high, 6.91" deep
6-12V ac 400 ma supplied by plug in wall transformer.
All metal - painted aluminum
11
white clipping circuits internally disabled)
separation and recombination artifacts)