Rear Panel Outputs - Klipsch THX ULTRA2 User Manual

REAR-PANEL OUTPUTS
REAR-PANEL OUTPUTS
1 COMPONENT VIDEO OUTPUT
One component video output is provided to connect to a monitor with a
component video input. This output is active only for routing the three
Component Video inputs (TV, DVD and Video) connected to component
video sources.
2 S-VIDEO MONITOR/RECORD OUTPUT
Two outputs are provided for S-video signals to route them to your moni-
tor or recording device. The Stage One does not convert composite video
input signals to S-video, although both composite and S-video signals can
be used simultaneously.
3 COMPOSITE VIDEO MONITOR/RECORD OUTPUT
Two outputs are provided for composite video signals to route them to
your monitor or recording device. The Stage One does not convert com-
posite video signals to S-video, although both composite and S-video sig-
nals can be used simultaneously.
4 TOSLINK OPTICAL DIGITAL OUTPUT
A Toslink optical digital audio output is provided on the rear panel. The
signal from the selected digital source is routed to the Toslink digital out-
put for recording purposes.
2
3
4
5
5 ANALOG RECORD OUTPUTS
Two sets of outputs are provided on the rear panel to connect to recording
devices, such as VCRs and tape decks. The analog signal from the
selected source is routed to both record outputs. (Be careful when
connecting these to a VCR line input if the VCR is the currently selected
source and line-in is selected on the VCR. This can cause a feedback
loop.)
6 PREAMPLIFIER OUTPUTS
RCA outputs are provided for each channel. Connect these to the inputs
of the corresponding power amplifier channels.
7 RS-232 IN/OUT
The RS-232 port enables the Stage One to communicate with external
control devices or to connect with expansion boxes for future
upgradability. This port also allows for software upgrades to be installed
to the Stage One.
8 12-VOLT DC OUTPUT
The 12-volt DC output can be used to trigger external devices that are
driven by a 12-volt continuous DC output (up to 100mA).
1
7
6
8
11