Common - QMOD -HDMI 2 Product Manual

Common

This series of menus sets global values for QMOD operation
Sets the physical channel, 2-135
Channel
Selects QAM 64 or QAM 256 (default). Fixed at 256 when 2-channel mode is enabled.
QAM
Continuous Wave is often used to test the channel with a meter.
256 | 64 | CW
Standard cable frequencies (default)
Cable format
HRC – same as Standard, channels 5 and 6 slightly different
IRC – All channel frequencies are different than the standard cable setting
Sets the RF level of the channel.
RF Level
29 | 25 | 21 | 17 | 13 | 9
IP Mode Selects Static (default) or DHCP IP modes
IP Address 192.168.1.231
Left/Right steps through each group, click Up or Down arrow to step one at a time, hold
down to move faster. Address also appears on LCD when QMOD restarts.
Gateway 255.255.255.000
Quad address – Left/Right steps through each group, click Up or Down arrow to step one
at a time, hold down to move faster.
Subnet Mask 255.255.255.0
Subnet has a limited range of combinations, so this function is simplified
Left/Right steps through each group, click Up or Down arrow for options
Telnet Port 2728 (default)
IP port for Telnet communication – Click or hold Up or Down to set.
Select outputs for stream, IP menus only appear when selected.
Output Stream
RF |IP|RF+IP
QMOD IP Port Enter IP address for IPTV
UDP Mode Selects UDP mode, sub menus change depending on mode
Unicast|Multicast
DstMultiAddr Enter IP address for multicast
Dest IP Addr Enter destination IP address for unicast
Dest IP Port Enter UDP port for unicast or multicast
MAC/SN Shows network MAC address
Ex: 00:04:9F:14:30:40 (last 2 bytes is the serial number)
LCD Contrast Contrast 1-15
LCD Bright Display brightness 1-16
Temperature Internal temperature
Fan Speed Set fan speed in percent
Backlight Display brightness 1-10
Activates inclusion of virtual channel ID and short Name in the video stream.
CVCT
On (default) | Off
Firmware version
FW version
Contemporary Research
 DHCP will select new address, will switch to static if network not present
 IP Address will show change when you select DHCP
 If you go back to Static, the address you defined in that mode will be set
6
QMOD-HDMI1.5