Advertisement
PANASTEREO CX230 CINEMA MONITOR
PANASTEREO CX230 CINEMA MONITOR
PANASTEREO CX230 CINEMA MONITOR
PANASTEREO CX230 CINEMA MONITOR
CX230 INSTALLATION continued
CONNECTING THE MONITOR SPEAKER OUTPUTS
2
Use medium gauge (minimum 0.75mm
) twin polarised wire (figure 8) between each of the monitor
speaker outputs and the monitor speakers. The monitor speakers can be 8 or 4 ohms.
If you are using only one speaker, connect it to the left channel output and set the
"MONO/STEREO" switch at the back of the monitor unit to the "MONO" position (IN). Otherwise
ensure that the "MONO/STEREO" switch is in the "STEREO" position (OUT).
CONNECTING THE SERIAL INTERFACE TO A COMPUTER AUTOMATION SYSTEM.
Use 4-core shielded computer or audio cable. The CX230 is configured as a DCE device (Data
Circuit Terminating Equipment), i.e. pin 2 = transmit data out and pin 3 = receive data in. Connect
one conductor to pin 2, one to pin 3 and one conductor to pin 5 (ground). The fourth conductor
can be left unused or also connected to pin 5 (ground). Solder the cable shield to the body of the
D-connector plug.
If the connection is to a DTE device (Data Terminal Equipment) such as a PC or the Panalogic
RC140 automation unit, the cable should be wired pin-for-pin (i.e. pin 2 to pin 2, pin 3 to pin 3, and
pin 5 to pin 5). If the connection is to another DCE device, pins 2 and 3 must be crossed over
(reversed) at one end.
Advertisement
