Subscribe to Our Youtube Channel
Related Manuals for Conrad FS20 TK 62 03 38
Summary of Contents for Conrad FS20 TK 62 03 38
- Page 1 OPERATING INSTRUCTIONS Version 12/06 Wireless doorbell transmitter „FS20 TK“ Item No. 62 03 38...
-
Page 2: Table Of Contents
Table of contents Page 1. Introduction ..................3 2. Prescribed use ................. 4 3. Scope of delivery ................4 4. Explanation of icons ................. 5 5. Safety instructions ................5 a) General information ..............5 b) Battery instructions ..............6 6. -
Page 3: Introduction
All rights reserved. For more inquiries, contact or consult our technical service: Germany: Tel. no.: +49 9604 / 40 88 80 Fax. no.: +49 9604 / 40 88 48 e-mail: tkb@conrad.de Mon. to Thur. 8.00am to 4.30pm Fri. 8.00am to 2.00pm... -
Page 4: Prescribed Use
Any use other than the one described above may damage the product and can also increase the risk of short-circuit, fire, electric shock, etc. All the safety instructions and installation notes in this manual must be observed without fail. 3. Scope of delivery • Wireless doorbell transmitter ‘FS20 TK’ • User manual... -
Page 5: Explanation Of Icons
4. Explanation of icons The icon with a lightning flash in a triangle is used to alert you to potential personal injury hazards such as electric shock. The icon with an exclamation mark in a triangle points to important instructions in this user manual that must be ob- served. -
Page 6: B) Battery Instructions
• The product is designed to be installed and operated in a protected outdoor area (for instance, under a projecting roof awning). • This product is not a toy and should be kept out of the reach of children. The product contains small parts and batteries. •... -
Page 7: Description Of Functions
13 ‘Dis- posal’. 6. Description of functions The wireless doorbell transmitter ‘FS20 TK’ is a component of the FS20 wireless switching system. The device can be used to transmit to any FS20 receiver device. -
Page 8: Installation
7. Installation The doorbell transmitter comes equipped with batteries, therefore it is ready for immediate mounting on the wall. • Working from the side, lever the facing from the catch using a small screwdriver. Place the device on a flat surface before carefully lifting the facing off. -
Page 9: Programming And Operation
The transmitter always sends a power-on command. The transmitter’s factory set house code is found on the back of the device ‘FS20 TK’. 9. Battery replacement The two LR44 (AG-13) button cells will last for up to 10 years, depending on the amount of use. - Page 10 • Lift off the lid and remove the two button cells from their holders (see illustration below). • Insert two new button cells into the holders with the plus poles facing up (see illustration). Always replace both batteries at the same time. Sender •...
-
Page 11: Information On The Range
10. Information on the range The transmitter has a range of up to 100m. This is the so-called free-field range, meaning the range when there is direct visual contact between the transmitter and the receiver. In practical operation, however, there are a number of ambient conditions which can reduce the range: •... -
Page 12: Handling
11. Handling The product may be installed in a protected outdoor area. Direct rain, or similar exposure, should be avoided. This product is not a toy and should be kept out of the reach of children. Even a fall from a low height can damage the product. 12. -
Page 13: Disposal
13. Disposal a) General information Do not dispose of electric and electronic products via the household rubbish. Once the product becomes unusable, dispose of it in accord- ance with the relevant statutory regulations. b) Batteries and rechargeable batteries As the consumer, you are legally obliged (regulation on the disposal of batteries) to return all your used batteries and rechargeable batteries. -
Page 14: Technical Specifications And Features
Dimensions (W x H x D): ....... 115 x 43 x 28mm 15. Declaration of conformity (DOC) We, Conrad Electronic, Klaus-Conrad-Straße 1, 92240 Hirschau (Ger- many), hereby declare that this product complies with the fundamental requirements and other relevant regulations of directive 1999/5/EG. - Page 16 Imprint These operating instructions are published by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau/Germany. No reproduction (including translation) is permitted in whole or part e.g. photocopy, microfilming or storage in electronic data processing equipment, without the express written consent of the publisher.
Need help?
Do you have a question about the FS20 TK 62 03 38 and is the answer not in the manual?
Questions and answers