Engine Speed Setting - Robin EY45V Service Manual

6. ENGINE S
6-1 CHOKE
and SPEED ADJUSTMENT
Operate the engine at no-load. Then, turn speed control lever toward "CHOKE" position until it just con-
tacts the choke/R.P.
M.
adjusting screw on choke lever (do not move choke lever.).
To
adjust the "CHOKE" start position and HIGH speed operating R . P . M . , use a tachometer or revolution
counter. Turn the adjusting screw in or out against the speed control lever until the desired no load operating
speed is obtained. This same position will be the start of the 'CHOKE' operation.
6 - 2 TO INSTALL REMOTE CONTROL WIRE
1. Use a control wire suitable for a .098" (2.5 mm) diameter wire hole and .236" ( 6 mm) diameter casing
hole.
2. Install control wire to engine by control wire bracket. Use pliers and pinch bracket around casing to
secure in place.
3. Insert the end of control wire into the speed control lever.
4. Place speed control lever in "LOW SPEED" position and tighten control wire lockscrew.
Governor Lever
Fig.
34
-
29
-