Zepco MDVR Getting Started

Getting Started

Embedded/Mobile Digital Video Recorder series
T
hank you for choosing our products. Please read these Instructions
carefully so you will know how to operate your MDVR properly.
After you have finished reading, please keep this document in a safe place
for future reference.
1. To reduce risk of fire and electronic shock, do not expose
T I P
this appliance to rain or moisture. Do not expose this device
with direct sunshine and keep away from high temperature.
2. Do not remove cover. No user-serviceable parts inside.
Refer servicing to qualified service personnel.
3. The information in this getting start was current when
published. The manufacturer reserves the right to revise and
improve its products. All specifications are therefore subject
to change without notice.
4. This device should be installed in a horizontal position.
-1-
MDVR Installation layout
Installation Caution: This device must be installed in a horizontal position.
T I P
Support 12V/3A-5A or 24V/3A. There are 3 cables of the
Power Input (Yellow, Red and Black). The yellow
one is used for signals, used to connect to the car's
ignition if MDVR is installed in the car. Engine is on or off
the car by turning the Key. If you test the MDVR in the
lab, you need to make the yellow cable and the red cable
of the power short circuit, so the MDVR will start.
T I P
Hitachi Brand 2.5 and Seagate mobile anti-vibration
1.
and shock resistance HDD are recommended
Compactable Flash Card:
2.
Kingston Brand is recommended
N O T E
The GPS antenna MUST be hypaethral (on the roof of the
vehicle), and should be horizontal and airward to make
GPS
sure the signal can be received.
-3-
-2-