Table of Contents
Advertisement
Playback may be directly through the machine's headphones power
stage (which permits connection of two stereo headphones) or through
the loudspeakers of your hi-fi sound system.
Procedure:
1.
Make certain that the amplifier connected for playback through the
sound system speakers is switched on - or that the headphones
are connected (see sees. 2.2, 2.4 and 2.7).
2. Switch on recorder by pressing POWER button © . The function indi-
cator above the STOP key © must light up.
3. Load tape reels and lock. Thread tape and wind onto take-up reel
past switching foil (see sees. 1.6 and 3.15).
1.8 Playback Operation for Users in a Hurry
4. Set a) tape type switch @ for tape used (see sec. 3.21),
5.
Lightly tip START key ® . The function indicator above the key should
light up, and tape transport should begin as soon as the OMEGA loop
is formed.
6.
Set volume as desired for headphones via headphones volume
control © , for loudspeakers via volume controls on the power ampli-
fier of the hi-fi sound system.
7. When playback is through the sound system amplifier, correct tone
and balance settings, if needed.
8. If necessary, set MONITOR switch (9) in off-TAPE position.
b) reel size switch @ (see sec. 3.24),
c) mode selector switch (f) to desired playback mode (see sec. 3.6)
and
d) tape speed selector ® (see sec. 3.8).
35
Advertisement
Table of Contents
