Page 1
LBI-38550A Maintenance Manual BASE STATION POWER SUPPLY 19A149978P1 - 120 VOLT/60 Hz 19A149978P2 - 230 VOLT/50 Hz CAUTION THESE SERVICING INSTRUCTIONS ARE FOR USE BY QUALIFIED PERSONNEL ONLY. TO AVOID ELECTRIC SHOCK DO NOT PERFORM ANY SERVICING OTHER THAN THAT CONTAINED IN THE OPERATING INSTRUCTIONS UNLESS YOU ARE QUALIFIED TO DO SO.
Ericsson Inc., at any time and without notice. Such changes will be incorporated into new editions of this manual. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording, for any purpose, without the express written permission of Ericsson Inc.
LBI-38550 IMPORTANT SAFETY INFORMATION 1. SAVE THIS MANUAL - It contains important safety 11. DO NOT operate this product in an explosive atmos- and operating instructions. phere unless it has been specifically certified for such operation. 2. Before using the product, please follow and adhere to all warnings, safety and operating instructions located 12.
Page 5
LBI-38550 Figure 1 - 60 Hz Power Supply (19A149978P1, Rev. B) Figure 2 - 50 Hz Power Supply (19A149978P2, Rev. A)
Amps. In the 60 Hz power supply (978P 1), the ON/OFF switch The 60 Hz Model (19A149978P1) operates from a (S1) provides line voltage to the power supply through the nominal 121 Vac, 60 Hz source. If a 208/220/240 Vac 60 Hz primary line fuse F1.
LBI-38550 load to prevent the output voltage from ever rising above 18 MAINTENANCE volts under any load condition. Under normal conditions jumper P802 is installed connecting the bleeder resistor For disassembly, remove 8 screws and lift off top cover. (SW GND) to A-. In 60 Hz models (Rev. A and earlier), Disassembly is required before working on the power sup- prior to Rev.
Page 8
LBI-38550 Figure 3 - 60 Hz Power Supply (19A149978P1, Rev. B) Figure 4 - 50 Hz Power Supply (19A149978P2, Rev. A)
Replace units are supplied with power. KEEP AWAY FROM fuse cover and secure using the 2 screws. LIVE CIRCUITS. Table 1 - 60 Hz Power Supply 19A149978P1 SYMPTOM PROCEDURE No output voltage at J801 Check the following: 1.
Page 10
LBI-38550 TROUBLESHOOTING PROCEDURE Table 2 - 50 Hz Power Supply 19A149978P2 SYMPTOM PROCEDURE No output voltage at J801 Check the following: 1. Open F1, F3, F4 or S1. 2. AC voltage on W801. 3. Open D1, D3 or D3. No output voltage at F801B Check the following: 1.
LBI-38550 PARTS LIST Ericsson Inc. Private Radio Systems Mountain View Road Lynchburg, Virginia 24502 1-800-528-7711 (Outside USA, 804-528-7711) Printed in U.S.A.