Advertisement
Connecting the AC Adapter
The included AC adapter must be used for proper clock operation and
should be connected by an adult.
• Plug the AC adapter cable into the DC adapter jack on the back of
the unit and connect the plug end into a working outlet that is not
controlled by a wall switch.
The AC adaptor shall be connected to the working outlet
where it is easily accessible. To disconnecting the device
Remove Demo Tab
from ac mains, unplug the AC adaptor from the outlet.
The unit has a demo tab for in-store demonstration purposes. Make sure
to remove this tab from the bottom of the unit. To do so, gently pull on
tab. Dispose of tab properly.
Installing/Replacing the Backup Batteries
This unit comes with 3 AAA batteries already installed. These are for
in-store demonstration purposes only and should be replaced when
you get the product home. When the included AC adapter is connected,
the batteries will serve as battery backup in the event of a power failure.
The batteries should be checked every 30 days and replaced if
needed.
1. Using a Phillips screwdriver, open the battery compartment door
located on the bottom of the unit.
2. Insert 3 new AAA (R03) batteries in the battery compartment.
Make sure batteries match the + and – as indicated in the battery
compartment diagram.
3. Replace battery compartment door. Do not overtighten screw.
WARNING : DO NOT THROW BATTERIES AWAY WITH
HOUSEHOLD TRASH. PLEASE CONSULT LOCAL
REGULATIONS
FOR
PROPER
DISPOSAL.
For the Best Possible Performance
• We recommend the use of alkaline batteries for longer life.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
• Batteries are to be inserted with correct polarity.
• Remove exhausted batteries from the unit.
• Do not attempt to recharge non-rechargeable batteries.
• Remove the rechargeable batteries from the unit before charging.
• The supply terminals are not to be short-circuited.
• Batteries should be removed if the item will not be used for an
extended period of time, such as a month or longer, to prevent battery
leakage or damage.
• Rechargeable batteries should only be charged under adult
supervision.
• Only batteries of the same or equivalent type recommended are to
be used.
Setting The Time
• Press and hold the Time Button until the display flashes.
• Press the Forward or Reverse Button to adjust the clock to the
current time (hold to set more rapidly). Make sure to set the correct
AM or PM time. The PM indicator appears to the lower right of the
time display; there is no AM indicator.
• Press the Time Button to confirm time setting.
Backup Battery Installation
BATTERY
Wake
Icon
Bedtime
Icon
Lift Snooze Button Cover
Light
Button
Dance
Button
Reverse
Button
Wake
Button
Top View of Castle
Snooze
Button
(Lift cover to access
time set and alarm set buttons,
including Reverse, Wake, Bedtime,
Time and Forward Buttons)
Time
Display
PM
Indicator
DC Adapter
Jack
Volume
Switch
Rear of Castle
Setting the Alarm
• Press and hold the Wake Button until the display flashes.
• Press the Forward or Reverse Button to adjust the display to the
desired alarm time (hold to set more rapidly). Make sure to set the
correct AM or PM time. The PM indicator appears to the lower
right of the time display; there is no AM indicator.
• Press the Wake Button to confirm. Alarm is active when the
appears on the display. To toggle alarm mode on or off, press
Wake Button at any time.
Snooze Button
Story
Button
Press down on the big Snooze Button located above the LCD screen
to snooze the Wake Alarm for 10 minutes.
Reset
Reset Button
Button
Press the Reset Button to stop a sounding Wake Alarm and reset it
Forward
to come on the next day at the same time.
Button
Setting the Bedtime Story Alarm
The Bedtime Alarm allows you to set the unit to play one of the
Time
2 built-in bedtime stories at your child's desired bedtime.
Button
• Press and hold the Bedtime Button until the display flashes.
• Press the Forward or Reverse Button to adjust the display to the
Bedtime
desired alarm time (hold to set more rapidly). Make sure to set the
Button
correct AM or PM time. The PM indicator appears to the lower
right of the time display; there is no AM indicator.
• Press the Bedtime Button to confirm. Alarm is active when the
appears on the display. To toggle bedtime alarm mode on or off,
press the Bedtime Button at any time.
Story Button
RESET
TEST
Press the Story Button as needed to cycle to and play each of the
2 built-in stories and to turn story mode OFF. Use the Story Button
when you want to hear a story right away without waiting for the
bedtime story alarm.
Light Button
The castle has a night light with 7 color settings. Press the Light
Button to cycle through these settings: Color change (fades
continuously through the 3 colors), green high, green low, amber high,
amber low, blue high, blue low and off.
Dance Button
Press the Dance Button to watch the two characters waltz while
music plays.
Advertisement
