Advertisement
Setting up your ZX Interface1
Unpacking
the
ZX
Interface
1 you
will
have
found:
-
this
booklet,
-
the
Interface
itself
(with
two
captive
screws
on the
underside),
-
a ribbon
cable
about
&ms
long
(for
connecting
the
Interface
to a
Microdrivel,
-
a lead
with
a jack
plug
at either
end
(for
setting
up a network).
To attach
the
Interface
to your
computer
you
should:
1. Unplug
the
computer.
2.
Disconnect
the
computer
from
its peripherals.
3.
Using
a Posidrive
screwdriver
remove
the two
screws
on the
underside
of the
computer,
as shown
in the
diagram
below.
(You
will
only
need
these
screws
again
if you
later
disconnect
the
Interface
from
the
computer.)
I
10
cl
I
Advertisement
