Do you have a question about the F01(RGY) and is the answer not in the manual?
Questions and answers
Summary of Contents for Beam F01(RGY)
Page 1
BEAM LASER USER MANUAL Model:F01(RGY)、F02(RGY)、K800 Please read this manual carefully before operating the LASER display system. www.bigdipper-laser.com Notices 1. Do not self disassemble or repair the system unless qualified in the relevant field of electronics. When there is a problem, please enquire or contact a qualified electrician, or with your local dealer.
Page 2
been installed. 10. Before connecting or disconnecting the power, adjust the luminance of the LASER diode to avoid any damage to it. 11. Before powering on the system, be sure the power cable is connected into the power socket. 12. Turn off the system for 25 minutes after running continuously for three hours;...
Page 3
Displaying more than 50 light beams and system should be 1.5 meters. At the same time, keep patterns, displaying laser patterns specified by international laser display association, such as Effect more than half a meter between the wall and LASER diffusing laser network.
Page 4
1-160 Manual move is the following 161-190 Automatic loop (from left to right) Horizontal 191-220 Automatic loop (from right to left) The 1st code is off------sound control mode( host laser) move Automatic loop (from right to left and right 221-255 to left) The 1st code is on------AUTO play mode( host laser) 1-160...
Need help?
Do you have a question about the F01(RGY) and is the answer not in the manual?
Questions and answers