Table of Contents
Summary of Contents for Northern 332101
- Page 1 " COMPOUND MITER SAW OWNER'S MANUAL WARNING: Read carefully and understand all INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury. Item # 332101...
-
Page 2: Intended Use
If you have any questions relative to a particular application, DO NOT use the machine until you have first contacted Northern Tool + Equipment to determine if it can or should be performed on the product. -
Page 3: General Safety Rules
GENERAL SAFETY RULES WARNING! Read and understand all instructions. Failure to follow all instructions list- ed below may result in electric shock, fire and/or serious injury. WARNING! The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions or situations that could occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. -
Page 4: Personal Safety
• Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. • Do not let your fingers touch the terminals of plug when installing or removing the plug to or from the outlet. PERSONAL SAFETY •... -
Page 5: Operation
• Use only accessories that are recommended by the manufacturer for your model. Accessories that may be suitable for one tool may create a risk of injury when used on another tool. • Keep guards in place and in working order. •... - Page 6 • Before you activate the On/Off switch, make sure that the saw blade is correctly fitted and that the machine's moving parts run smoothly. • Before you connect the machine to the power supply, make sure the data on the rating plate is the same as that for your main power.
- Page 9 Adjusting the Saw (Figs. 1 and 2, Parts Diagram) • To adjust the turntable (8), loosen the locking grip (10) by turning it through 2 complete rotations to unlock the turntable (8). • The turntable (8) can be set to 0°, 15°, 22.5°, 30° and 45°. As soon as the turntable (8) has engaged, the position must be fixed by tightening the locking grip (10).
- Page 10 Precision adjustment of the stop for 90° cross-cuts (Fig. 6/7) • Lower the saw head and fix with the lock pin. • Slacken the locking nut (12). • Place the stop angle (a) between the saw blade and the turntable. •...
-
Page 11: Maintenance
• Undo the clamping nut and, holding the handle, tilt the machine head to the left to the required angle dimension. • Retighten the clamping nut. Chip extraction (Fig. 2) The saw is equipped with a chip collection bag (14). The chip bag (14) can be emptied by opening the zip fastener at the bottom. -
Page 12: Diagram & Parts List
DIAGRAM & PARTS LIST...
Need help?
Do you have a question about the 332101 and is the answer not in the manual?
Questions and answers