Functional Instructions; Features And Operational Controls - Hifonics Vulcan VXi1201 Owner's Manual

Vulcan series, analog class a/b mono amplifier

Hide thumbs

Table of Contents

Available languages

FEATURES AND OPERATIONAL CONTROLS

POWER/PROTECT

If the POWER LED lights up, the amplifier is ready for operation.

If the PROTECT LED lights up, a malfunction is indicated. Refer in this case to the chapter TROUBLE SHOOTING.

The BASS REMOTE CONTROLLER port is for the cable of the enclosed bass remote controller and only to use in the MASTER

mode. With this bass remote controller, you are able to adjust the bass level e.g. out of the driver's seat. Please use only the

enclosed bass remote controller and cable.

The X-OVER MODE switch selects the required operation mode of the amplifier.

In the LP/BP-Mode (Low Pass / Bandpass mode) you are able to limit the frequencies to above with the LP controller an to below

with the SUB SONIC controller.

In the HP-Mode (HIGH PASS mode) you are able to limit the frequencies to below with the HP controller.

In the FULL-Mode a full range signal will be provided to the speakers. The controllers PHASE, LP, SUB SONIC and the BASS

LEVEL CONTROLLER are without function.

The LEVEL controller adjusts the input sensitivity of the amplifier, to adjust the audio signal of the headunit. The input sensitivity

is adjustable from 6 Volts (MIN) to 0.2 Volts (MAX).

The BASS BOOST controller defines the bass bosst from 0 to 12dB @ 45 Hz.

The PHASE controller allows to adjust the phasing between 0° and 180°. Hence, you are able to adjust the subwoofer perfect

to the vehicle's acustics.

The LP controller adjusts the cut-off point of the frequency range to above. The cut-off frequency is continuously adjustable from

35 Hz to 250 Hz.