Wireless Network; Step 4: Test Wireless Connection; Important Recommendation - Egardia CAMERA Installation Manual

Please note! You are probably
using a encryption key provided by
your internet provider. If your
wireless network is not secured we
strongly advise you to do so
without delay to prevent
unwarranted intrusion.
You can adjust the focus by
turning the camera lens.

Wireless network

Encryption: select the type of encryption you use to secure your wireless network. Depending on
your choice insert your encryption key.
Network name/SSID: enter the name of your wireless network. Please note! Network names are
case sensitive!
To activate the camera you must first agree to the Egardia Terms & Conditions at the bottom of the
webpage. This subscription will allow you to connect and configure up to four Egardia cameras.

STEP 4: TEST WIRELESS CONNECTION

This step is only necessary if you are planning to use your camera in wireless mode.
1. Disconnect the Ethernet cable from the camera.
2. Switch the camera off by removing the power adapter from the power supply and wait for 20
seconds.
3. Reconnect the power adapter to the power supply. The camera is ready for wireless use.
You may view your live video images at your Egardia account under the tab "Cameras". Please note
that it may take up to two minutes before the first video images appear. You may have to focus for
sharper images by turning the lens.
Congratulations! The installation is complete.
Please note! If you do not see any video images after 3 minutes, disconnect the power adapter from
the power supply of the camera. Reconnect the Ethernet cable and then the power adapter to the
power supply. Login at your Egardia account and go to the tab "Cameras". Click "Change settings"
and re-enter your network settings.

Important recommendation

Egardia automatically saves the recordings for 30 days. To prevent deletion after 30 days, check
the "Save" box next to the particular recording under the tab "Cameras" at your Egardia account.
3