Page 1
FREESTANDING PELLET STOVE (PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE) EN 14785 BImSchV Stufe 2 certified by TÜV SÜD Germany A LIFETIME OF WARMTH *Please read this entire manual before installation and use of this pellet fuel burning room heater. Failure to follow these instructions could result in property damage, bodily injury, or even death.
230/50 230/50 Average Electrical consumption FUSE Efficiency 90.6% 88.4% CO2 CONTENT CO emission re. 13% O2 Mg/NM3 Dust emissions Mg/NM3 Exhaust air mass flow Exhaust air temperature Chimney draft requirement K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Rear Cover. 18Bottom Clear cover. 19 top clear covers 20. Display. 21. exhaust connection. 22. Power input socket(contains the main fuse). 23.Room temperature Sensor. 24. Handle. 25 Stove adjustable Feet. 26 fire chamber. 27. Safety temperature Sensor. 28. Exhaust temperature sensor K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 6
This safety switch is installed on the bottom of hopper and will shut off the heater if it senses excessive temperatures (70 degrees). CONVECTION BLOWER THERMOSTAT This switch is installed on the vent pipe and turns the convection blower on when the heater is above 40 degrees. K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
In addition you must ensure that the flue tube does not project into the free cross section of the chimney. NOTE: Please follow the regionally valid building regulations. Contact your master K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 8
Where you cannot connect directly to the chimney, if possible use a connection piece with cleaning opening. For optimum efficiency please use the type of connector we recommend. MAKING THE CHIMNEY CONNECTION Horizontal K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 9
4. Connect stove with the flue tube to the chimney. FLOOR PROTECTION For flammable floor surfaces (wood, carpet, etc.) a glass, steel plate or ceramic underlay is required. SAFETY DISTANCES K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 10
Steel, HT or flexible aluminum pipes must be used. Minimum diameter 5 cm/2 inches. For longer connection runs, the diameter must be increased to approx. 10 cm after approx. 1 m. K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 11
Note: Keep the fire pot and its underneath clean when every time you start the stove! Put wood pellet fuel into the hopper, connect the power. Then On/Off Light is Lighting (It means K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 12
Please operate the stove as following (refer to stove structure figure and electrical control figure): Check the box, pellet grate bar , a sh pan then adjust to proper position. K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 13
1. Operations Instructions - Quick reference guide K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 14
GOODBYE’ is minutes will spend necessary for the flame displayed. stabilization. This phase is showed from the message ‘STABILIZATION” which finishes after some minutes going up at the work phase ↑ K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 15
Whether the heater is switched or not, on the display will display the hour, the power, and the planned set temperature. Note: If the new stove, when its first time using, it is necessary to put a hand of pellet to the fire pot before hand. K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 16
After the room temperature drops down, and below the set out temperature (3degrees), it automatically, switching on again or come back to the previous Power level. Later how to select these two functions will be shown. K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 17
The number with “S” is the temperature for the Smoke The number with “P” is the temperature for the Protection. For example: It means that the room temperature is 13 degree. K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 18
3.) How to set details Setup - Quick reference guide K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 19
K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 20
The following is P6; this data is related to the exhaust fan’s speed of the “Feeding”, “Lighting” and some minutes of “Stabilization” stage. The adjustable range is also from 20 to -20 K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 21
, the time can be amended: You can select week or time by keys also using to change the day or time , to save the correct data by press and move to next stage. K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 22
On the above line it is showed the day which is programming, the hour with the functioning state. On the below line the programmed hour are displayed. Lower one means off, taller on means on, which also shows on superior line • K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 23
Keeping pressing the key it will appear the following words , you can choose Yes, Or No. “Yes”- go back factory setting “NO” - use the data you have changed. K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 24
There is some leakage about the stove or runs not properly exhaust pipe is blocked and so on. During operation, stove It means you need to cleaning the stoves. interrupted by electronic cut. K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 25
On power failure a small amount of smoke may be emitted. This does not last for more than three to five minutes and does not represent a safety risks. POWER INPUT SOCKET (contains the main fuse) ELECTRIC EXCESS-CURRENT SHUT OFF K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 26
EXHUASTED TEMPERATURE SENSOR FUNCTION AS LOW TEMPERATURE SWITCH OFF If the stove cools down below a minimum temperature, then the stove will switch off. This switch off can also occur if pre-heating is too slow. K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
However the ash should be aged first and “quenched” with water CAUTION: Embers may be hidden in the ash – empty only into metal containers. K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 28
(see the picture as follows) that can be removed by unscrewing the two 5/32’’ allen head screws. Insert a cleaning brush in the openings to loosen any ash buildup K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 29
Rotate the covers back over the holes and tighten the screws. Front View Looking into the Ash Drawer Cavity with the Ash Drawer Removed. HOW TO CLEAN THE STOVE K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 30
Sweep the pipe as needed. A tee and the cleanout in the vent system attached to the stove’s flue collar will facilitate this cleaning. Required Cleaning Schedule after Number of Bags Burned K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 31
Burned high ash pellets will require more frequent cleaning. We do advise to use only certified pellets as mentioned on page 3 ( Burn only pellets that have been tested and certified with EN-A1-plus) ask your dealer for advise. K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
7. Troubleshooting HOW TO REPLACE INGITION BAR AND AUGER SYSTEM HOW TO REPLACE THE ROOM FAN(BLOWER) K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 33
HOW TO REPLACE THE COMBUSTION FAN The general troubles, the possible reasons and the solutions are as following, after solving K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 34
3. No feeding after 20 seconds of starting. There are three stages for the feeding process. One is during the several minutes, feeding is constantly. "Feeding" is showing on the LCD K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 35
Pressure Switch is broken Replace or repair the device in the stove 6 orange and lazy fire, Lack of air intake for Clean the block in gate bar. K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 36
Clean the heat exchange tubes or flue pass are dirty. flue pass. 10. Showing "E5" on the Vent pipe is blocked Shut down the stove, check the display venting pipe K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 37
However, the generator’s electrical regulator may not be compatible with the stove’s electronics. The higher the quality of the generator, the greater the chance that it is compatible with the stove. K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 38
Any costs incurred by the manufacturer due to unjustified warranty claims are to be charged to the claimant. THE WARRANTY DOES NOT AFFECT THE STATUTORY WARRANTY PROVISIONS. K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
9.Electronic Plan K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...
Page 40
Tel: +353 56 444 1988 Fax: +353 56 444 1978 Freefax: 1800 200 650 sales@doylesw.ie www.doyles.ie Your dealer is: Do Not forget to register your K-Stove pellet stove via: http://www.kstove.com/kstove/register/ K-Stove® is a brand of DMS-Europe BV NL-3641AR-2 The Netherlands...