Installing The Front Wheel - Razor Dirt Rocket SX500 Owner's Manual

ASSEMBLY AND SET-UP

Installing the Front Wheel

Tools required: 14 mm wrench and 17 mm wrench (MX500/MX650 Models)
17 mm wrench and 19 mm wrench (SX500 Model)
1
Position wheel in front fork and
slide disk brake into caliper.
MX500/MX650 Models
3
With a 14 mm and 17 mm
wrench, tighten the front wheel.
Inflating the Tires
Tires are inflated when shipped, but they invariably lose some pressure between the point of manufacturing
and your purchase.
1
Using a bicycle-style tire
pump equipped for a Schrader-
type valve, inflate the front tire to
the correct PSI indicated on the
sidewall of the tire.
Fork
Nut
Washer
Spacer
2
Slide axle through fork, spacer and wheel hub. When axle passes through
the other side of the wheel hub, add the other spacer, and slide though the
fork. Secure with washer and nut.
Note: Front axle is installed with the spacer between the fork and wheel for
all Dirt Rockets.
SX500 Model
3
With a 17 mm and 19 mm
wrench, tighten the front wheel.
Fork
Axle Blot
Spacer Washer Nut
5
WARNING: Failing to
properly adjust and tighten the nuts
and bolts that affix the fork can
cause you to lose control and fall.
WARNING:
Do not over inflate, as this could
damage tire or wheel.
Note: The pressurized air supplies
found at gasoline stations are
designed to inflate high-volume
automobile tires. If you decide to
use such an air supply to inflate your
motor bike tires, first make sure the
pressure gauge is working, then
use very short bursts to inflate to
the correct PSI. If you inadvertently
over-inflate the tire, release the
excess pressure immediately.