Do you have a question about the Tornado-AS and is the answer not in the manual?
Questions and answers
Summary of Contents for Tritech Tornado-AS
Page 1
Operator & Installation Manual The electronic version of this document is the controlled copy. Therefore all printed versions of this document are uncontrolled. For the latest manual revision always visit – www.tritech.co.uk Supplied by Issue 3 TIL – Eng – Spec – 033...
Tritech International Ltd Tornado Camera OIM CONTENTS Handling of Electrostatic-Sensitive Devices WARRANTY STATEMENT Safety Statements Technical Support INTRODUCTION Optional features OPERATING CONDITIONS SETTING UP PROCEDURES Long line amplifier (Rev B) DISASSEMBLY PROCEDURES APPENDIX 1 Product Specification APPENDIX 2 Tornado Camera Pin Configuration...
Tritech International Ltd Tornado Camera OIM Handling of Electrostatic-Sensitive Devices Attention Observe Precautions for handling Electrostatic Devices Caution Handling of Electrostatic-Sensitive Devices Certain semiconductor devices used in the equipment are liable to damage due to static voltages. Observe the following precautions when handling these devices in their unterminated state, or sub-units containing these devices: •...
Tornado Camera OIM WARRANTY STATEMENT Tritech International Limited herein after referred to as TIL TIL warrants that at the time of shipment all products shall be free from defects in material and workmanship and suitable for the purpose specified in the product literature.
Danger! highlighted by the adjacent symbol and text. Technical Support Contact your local agent or Tritech International Ltd Tritech International Ltd. Peregrine Road, Mail Westhill Business Park,...
The camera should not be used out of the limit conditions specified in this manual. For any special requirement please contact TRITECH INTERNATIONAL LTD. Before attaching the connector to the camera ensure that the O’ring is on position, clean and lightly smeared with silicon grease.
Tritech International Ltd Tornado Camera OIM SETTING UP PROCEDURES Power supply The power supply output is controlled through a potentiometer VR1 fitted on the topside of the PSU/Mother board. It is set at the factory and does not require any further adjustment.
Tritech International Ltd Tornado Camera OIM DISASSEMBLY PROCEDURES To access the internal part of the camera, first remove the nylon retaining cord from the connector end-cap end of the camera. (It is not necessary to extract the nylon cord fitted between the front part of the housing and the lens-retaining ring.)
Page 10
Tritech International Ltd Tornado Camera OIM ILLUSTRATION TORNADO-AS Issue 3 TIL – Eng – Spec – 033 Page 11 of 14...
Need help?
Do you have a question about the Tornado-AS and is the answer not in the manual?
Questions and answers