Advertisement
IMPORTANT SAFETY INSTRUCTIONS
CAUTION:
Read and understand all safety and operating instructions in this
manual before attempting to install or operate this product. READ ALL
INSTRUCTIONS! SAVE THESE INSTRUCTIONS!
WARNING: Read these instructions. Consult a qualified electrician if
you are not certain about the installation process. Always install wiring
connections in accordance with local code, ordinances and the National
Electrical Code.
PREPARATION
Before beginning installation of product, make sure all parts are
present. Compare parts with package contents list and diagram
above. If any part is missing or damaged, do not attempt to install the
product. Contact customer service for replacement parts.
• Estimated Installation Time: 30 minutes. Installation time will vary
depending on skill level and existing conditions.
• Items Required for Assembly: Phillips screwdriver, slotted
screwdriver, wrench or pliers, silicone caulking adhesive (not included)
• Suggested Items to have on-hand: Step ladder (not included).
3
Page
SAVE THESE INSTRUCTIONS!
ASSEMBLY INSTRUCTIONS
1. Install fixture using the keyhole slots located on the rear of the unit.
Screw the two screws provided into a suitable surface spaced at 4
7/8", (124mm) apart with approximately 7/16", (10.5mm) of the screw
remaining above surface. Align the keyhole slots over the screws, push
the unit over the screw
head and then down to
lock the unit into place.
CAUTION:
RISK OF SHOCK. Aim
lamp head down
20 degrees below
horizontal in order to
prevent water from
accumulating inside.
2. Using the two screws
provided mount the solar
panel where it will receive
full sun. Plug the power connector into the connector labeled SOLAR
SAVE THESE INSTRUCTIONS!
PANEL. Store the unused cable in the
space provided under the solar panel
mount.
IMPORTANT: After mounting the
fixture the battery needs to fully
charge. Turn the OFF /AUTO switch
to the OFF position and let charge
in full sun for a minimum of 72
hours. CAUTION: Make sure motion
detector head is not UPSIDE DOWN!
Turn the head so the controls face
the ground. If the head is turned
upside down, the motion detector
can be damaged by rain!
4
Page
Advertisement
