Advertisement
Available languages
Available languages
If the induction cooker
operates for two hours and no
key is pressed in working
mode, it will go to standby
mode automatically (except
that timing period exceeds two
hours).
1-Minute Auto Shutdown
Protection:
If the pot is moved away, the
induction cooker will stop
heating immediately. After the
buzzer sound about 1 minute,
it will go into standby mode
automatically.
Failure and Protection Code:
If an abnormally comes up, the
induction cooker will enter
protective mode automatically
and display corresponding
protective codes.
Code
Failure
Utensil not placed
E1
Supply voltage too high
E2
transducer of the heat
sink
Supply voltage too low
E3
Bottom of the pot over
E4
heated
Heat sensor open circuit
E5
or short circuit
Over current protection
E6
11
Code
Main PCB at Fault
E7
Top plate over heat
E8
Applicable Pots:
- Please use the pots sold along
with the unit by recommended.
- It is better not to use other ,
alternatives so as to avoid any
unfavorable influence on the
operational performance.
- If using other pots, please
observe
the
conditions:
*Requirement for pot materials:
containing magnetic inducting
materials.
*Shape requirement: flat bottom,
the diameter within the range of
12cm. and 22cm.
- During operating, you may hear
high-frequency
magnetic noise, which is caused
Failure
following
electro-
Advertisement
