Subscribe to Our Youtube Channel
Summary of Contents for Laing Thermotech Autocirc ACT E10
- Page 1 INSTRUCTION MANUAL 6-71-075-109 REVISION A Autocirc Instant Hot Water Pump ® Model: ACT E10...
- Page 3 Preparation for Installation: Assemble the parts and tools required: 1. Open and inspect Autocirc pump package. 2. Autocirc pump package includes the pump with a built-in ti mer, a 6ft. cord, and wall mounting bracket. 3. Two stainless steel flexible hoses (1/2” x 3/8”) - length as required. (sold separately) 4.
- Page 4 Remove the existing flexible line connection to the hot and cold water faucet/tap threaded nipples (see Fig. 3). (TIP: Mark the hot and cold water flexible lines to easily identify them). Note: If necessary, replace the existing flexible hoses with new stainless steel braided flexible hoses in the lengths required.
- Page 5 Note: The above installation method applies to most situations where faucets/taps are connected to the hot and cold water supply lines with braided flexible hose/shut off valve arrangements. If the under sink arrangement is different (i.e. the risers are hard copper or plastic), then other parts may be required for the installation.
- Page 8 Xylem Inc. 3878 S. Willow, Suite 104 Fresno, CA 93725 Tel: (559) 265-4730 (800) 554-6853 Fax: (559) 265-4740 (800) 453-7523 www.xyleminc.com/brands/laingthermotech Laing Thermotech is a trademark of Xylem Inc. or one of its subsidiaries. © 2012 Xylem, Inc. 6-71-075-109A July 2012...
Need help?
Do you have a question about the Autocirc ACT E10 and is the answer not in the manual?
Questions and answers