Installing The Auxiliary Handle; Installing The Guard - Toro 51487 Operator's Manual

3

Installing the Auxiliary Handle

Parts needed for this procedure:
1 Auxiliary handle
1 Latch
1 Brace
Procedure
1. Position the auxiliary handle on the shaft of the trimmer with
the smooth surface facing the operator (Figure 5).
1. Auxiliary handle
2. Latch
2. Slide the brace into the auxiliary handle so that the brace
rests in the groove along the shaft (Figure 5).
3. Slide the latch from the left through the handle and brace
as shown and tighten the latch screw with a Phillips head
screwdriver (Figure 5).
G017277
Figure 5
3. Brace
4

Installing the Guard

Parts needed for this procedure:
1 Guard
1 Phillips head screw
Procedure
1. Remove the Phillips head screw taped to the guard
(Figure 6).
2. Slide the guard onto the trimmer base as shown in Figure 6.
G017622
1. Phillips head screw
3. Secure the guard using a Phillips head screw.
7
Figure 6
2. Guard