Table of Contents
Advertisement
After the door has been reversed, you should check
the door seal of the appliance. The seal should not be
creased or crushed; otherwise there will be a gap
between it and the inside of the door.
o The seal must adhere properly all the way around the door.
o If the seal is not adhering to the cabinet properly, then you
should either:-
1.Use a warm damp cloth and manipulate the seal until it does
adhere to the cabinet properly, all the way around the door.
OR
2.Use a hair dryer on its lowest heat setting and lightly heat the
areas of the door seal that are not adhering correctly. The
heat will make the seal more pliable and this will allow you to
manipulate the seal into the correct position.
IMPORTANT: DO NOT HEAT THE DOOR SEAL ON ANYTHING BUT
THE LOWEST HEAT SETTING, OR HEAT THE SEAL FOR A LONG
PERIOD OF TIME. OTHERWISE DAMAGE MAY BE CAUSED TO
THE DOOR SEAL, WHICH WOULD NOT BE RECTIFIED UNDER
THE GUARANTEE FREE OF CHARGE.
IMPORTANT: WHEN YOU HAVE REVERSED THE DOOR OF THE
APPLIANCE.
IF
BACKWARDS,
YOU
SWITCHING THE APPLIANCE BACK ON.
Troubleshooting
IMPORTANT: If your fridge appears not to be
operating properly, before contacting the Baumatic
Customer Care Department, please refer to the
checklist below.
My fridge does not appear to be working/there is no
power to my appliance.
o Check that the plug is fully inserted into the power socket.
o Check that there is power to your mains supply (e.g. that there
hasn't been a power cut or that the fuse hasn't blown).
YOU
HAVE
TILTED
MUST
WAIT
THE
APPLIANCE
FOR
8
HOURS
BEFORE
20
Advertisement
Table of Contents
